162114
4
Zoom out
Zoom in
Previous page
1/32
Next page
4-English
Installation Procedure
To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the
battery.
Make the proper input and output cable connections for each unit.
Connect the wiring harness cables in the following order: ground, battery, ignition.
Connect the wiring harness connector to the unit.
Install the unit in your car.
Reconnect the · terminal of the battery.
Press the reset button.(See page 4)
7
6
5
4
3
2
1
If your car's ignition does not come with an ACC position, connect the ignition cables to a power
source that can be turned on and off with the ignition key. If you connect the ignition cable to a
power source that receives a constant voltage supply, as with battery cables, the battery may die.
If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the
old fuse with one with the same rating.
Do not let unconnected cables or terminals touch metal on the car or anything else conducting
electricity. To prevent a short circuit, do not remove the caps from unused terminals or from the
ends of the unconnected cables.
After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
Insulate unconnected cables with vinyl tape or other similar material.
Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
2CAUTION
Reset
When installation is complete, check the connections.
If everything is in order, press the reset button. If the
unit does not seem to be working right, try pressing the
reset button first.
If that does not solve the problem, consult your
Kenwood dealer.
The Mark Position of Your Car Immediately After Installation
•Immediately after installation, the information of the GPS satellite is taken in and it may take
several minutes to measure the position of the current location.
Immediately after installation, the initial value setting of the gyro sensor is required. After
measuring the position of the current location, drive of about 6.2 mile (10 km) and further at a
constant speed at least 24.8 mile/h (40 km/h) in a place where there are few obstacles (for
example, buildings and tree-lined streets).
Until the initial values are set, the position and speed indication of you car's mark on the navigation
system may differ greatly from the actual values.
The proper connection of the car speed signal cable can be checked with the menu screen.
Please see the instruction manual for details.
NOTE
English
KNA-DV3200Inst(E) 03.5.8 2:41 PM Page 4
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood kna-dv3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood kna-dv3200 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood kna-dv3200

Kenwood kna-dv3200 User Manual - German - 60 pages

Kenwood kna-dv3200 User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info