To dismantle the juicer reverse the assembly procedure but press the pulp
container release lever in order to remove the pulp container from base unit.
●
Alternatively if you want to juice a large quantity of fruit or vegetables and
just want to empty the beaker and pulp container carry out the following
procedure:-
1 Switch off and unplug the mixer.
2 Unlock the attachment lid and lift off.
3 Lift out the filter,
4 Swivel the beaker holder to the side, lift off the beaker and empty.
5 Press the pulp container release lever and rotate the pulp container anti-
clockwise and lift off.
6 Empty the pulp container of waste.
7 Re-assemble the unit.
important
●
If the juicer starts to vibrate, switch off and empty the pulp from the filter.
(The juicer vibrates if the pulp becomes unevenly distributed).
●
Maximum capacity that can be processed at one time is 500g of fruit or
vegetables.
●
Some very hard foods may make your attachment slow down or stop. If this
happens switch off and unblock the filter.
●
Switch off and empty the pulp and juice containers regularly during use.
hints
●
Insert soft food slowly to get the most juice.
●
Vitamins disappear - the sooner you drink your juice, the more vitamins
you'll get.
●
If you need to store the juice for a few hours put it in the fridge. It will keep
better if you add a few drops of lemon juice.
●
Don't drink more than three 230mls (8 fl.oz.) glasses of juice a day unless
you're used to it.
●
Dilute juice for children with an equal amount of water.
●
Juice from dark green (broccoli, spinach etc) or dark red (beetroot, red cabbage
etc) vegetables is extremely strong, so always dilute it.
●
Fruit juice is high in Fructose (fruit sugar), so people with diabetes or low
blood sugar should avoid drinking too much.
care and cleaning
●
Always switch off and unplug before removing attachment from mixer.
●
Dismantle the attachment fully before cleaning.
●
For easier cleaning always wash the parts immediately after use.
●
Never let the base unit get wet.
●
Some foods, eg carrot, will discolour the plastic. Rubbing with a cloth
dipped in vegetable oil helps remove discolouring.
base unit
●
Wipe with a damp cloth, then dry.
filter
●
Clean using a soft brush.
●
Check the filter regularly for signs of damage. Do not use if
the filter is damaged. Refer to “service and customer care”.
other parts
●
Wash, then dry. Alternatively they can be washed on the top rack of your
dishwasher. A short low temperature programme is recommended.
Multi food grinder AT281 (if supplied)
Use the multi food grinder to process raw and cooked meat; fish and nuts.
safety
●
Always ensure bones and rind etc are removed from the meat before
mincing.
●
When mincing nuts only feed a few down at a time and allow the scroll to
pick them up before adding any more.
●
Always use the pusher supplied. Never put your fingers or utensils in the
feed tube.
●
Warning - the cutting blade is sharp, handle with care both in use and when
cleaning.
●
Ensure the attachment is secured in position before switching on.
key ት
ቢ ring nut
ባ multi food grinder screens: medium, coarse (due to model variants only 1
screen may be supplied)
ቤ cutter
ብ scroll
ቦ multi food grinder body
ቧ tray
ቨ pusher
to assemble
1 Fit the scroll inside the multi food grinder body.
2 Fit the cutter – cutting side outermost ᕡ. Ensure it’s seated properly –
otherwise you could damage your multi food grinder.
3 Fit a multi food grinder screen ᕢ. Put the notch over the pin.
4 Loosely fit the ring nut.
to use the multi food grinder
1 Raise the mixer head.
2 With the multi food grinder in the position shown ᕣ, align the drive tabs on
the end of the scroll with the corresponding slots in the drive outlet.
3 Push the multi food grinder into the outlet and turn clockwise until it locks
into place.
4 Tighten the ring nut manually.
5 Fit the tray ᕤ.
6 Thaw frozen food thoroughly before mincing. Cut meat into 2.5cm
(1”) -wide strips.
7 Switch to maximum speed by turning the speed switch in a clockwise
direction. Using the pusher, gently push the food through, one piece at a
time. Don’t push hard – you could damage your multi food grinder.
important
●
Never operate the multi food grinder attachment for longer than 10 minutes
as this could damage your mixer.
●
The multi food grinder attachment will not operate unless the
medium and high speed outlet covers are fitted.
8 Once all the food has been minced, switch off and unplug.
9 Remove the multi food grinder.
care and cleaning
●
Always switch off and unplug before removing the attachment from the
kitchen machine.
●
Dismantle the attachment fully before cleaning.
●
Wash all the parts in hot soapy water, then dry thoroughly. Don’t wash
any part in the dishwasher. Never use a soda solution.
●
Wipe the screens with vegetable oil, then wrap in greaseproof paper to
prevent discolouring/rusting.
8
