510889
5
Zoom out
Zoom in
Previous page
1/40
Next page
Assembling Bowl and Attachments Cont...
To fit attachments to the beater
socket, raise the mixer head.
Gently slide the attachment into
the outlet turning slowly in the
direction shown in the diagram,
until a stop is reached.
Press firmly upwards until the
attachment clicks into position.
To remove the attachment turn
clockwise until it is free to
withdraw.
Note
The 'K' beater and whisk were correctly set in the factory and should not need further adjustment.
If for any reason adjustment becomes necessary proceed as follows:
1.
Disconnect mixer from mains supply.
2.
Raise the head and insert beater/whisk attachment to be adjusted.
3. Hold the attachment and slacken nut with a suitable spanner (C).
4.
Lower the head and rotate the attachment up or down the shaft (D). For best results the beater/whisk
should be as close to the base of the bowl as possible.
5. Raise the head and holding the attachment tighten the nut.
Hint
If when the machine is run, the
'K' beater knocks the bowl,
then adjustment is too low.
To remove the slow speed outlet
cover, pull the locking catch to
the side and pull off the cover.
Remove the juice extractor outlet
cover by either pressing down
and lifting free, or simply by lifting
free.
If a plastic plug is fitted,
unscrew this before fitting the
attachment.
Remove the high speed outlet
cover by lifting free.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood KM200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood KM200 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood KM200

Kenwood KM200 User Manual - English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish - 153 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info