706631

Kenwood KHH322WH Manual

16
Zoom out
Zoom in
Previous page
1/327
Next page
to assemble the food mincer
1 Fit the food mincer scroll
E
inside the food mincer
body
F
.
2 Fit the cutter
D
– cutting side outermost. Ensure
it is seated properly, otherwise you could damage
your food mincer.
3 Fit a screen
C
. Put the notch over the locating
tab
cn
.
4 Loosely fit the ring nut
B
.
to assemble the pasta maker
Optional: for easier pasta making, warm the parts in
hot water before assembling. Then dry thoroughly
before assembling.
1 Fit the pasta scroll
J
inside the food mincer
body
F
.
2 Fit a screen
K
,
L
,
M
or
N
. Put the notch over
the locating tab
co
.
3 Loosely fit the ring nut
B
.
to fit the attachment to the
machine
1 Raise the mixer head.
2 With the attachment in the position shown, align
the drive tabs on the end of the scroll with the
corresponding slots in the bowl tool socket
cp
.
3 Push the attachment into the socket and turn anti-
clockwise until it locks into place.
4 Hold the feed tube in place and tighten the ring nut
by hand.
5 Fit the tray
cq
.
important
l
Never operate the attachment for longer than 10
minutes as this could damage your mixer.
l
The attachment will not operate unless
the dual speed outlet cover is fitted.
to use your food mincer
l
Thaw frozen food thoroughly before
mincing. Cut meat into 2.5cm (1”) wide strips.
1 Switch to maximum speed. Using the pusher
I
,
gently push the food through one piece at a time.
Do not push hard – you could damage your
food mincer.
2 Once all the food has been minced, switch off and
unplug.
3 Remove the food mincer. Use the spanner
A
to
remove the ring nut if it is too tight.
to use the pasta maker
1 Make your pasta dough. – a too-dry mix could
break your pasta maker.
2 Switch to maximum speed.
3 Place some of the mix onto the hopper. Feed a
small amount of mix into the feed tube at a time.
Allow the scroll to clear before continuing.
If the feed tube becomes clogged use the end
of the spanner handle
A
to push the mix onto
the scroll. Do not push too hard or use the
mincer pusher – you could damage the
pasta maker. Never let the feed tube fill up.
4 When the pasta is long enough, cut to the desired
length.
5 Remove the pasta maker. Use the spanner
A
to
remove the ring nut if it is too tight.
l
Cook rigatoni within 4 hours. Otherwise it will
become brittle and snap.
to cook your pasta
1 Bring a pan three quarters full of water to the boil.
Add salt to taste.
2 Add your pasta and gently boil for 3- 8 minutes,
stirring occasionally.
cm
compact chopper/grinder
attachment
A
jar
B
sealing ring
C
blade unit
to use your compact chopper/
grinder
Use the compact chopper/grinder for milling herbs,
nuts and coffee beans.
1
Put the ingredients into the jar
A
.
2
Fit the sealing ring
B
into the blade unit
C
.
l
Leaking will occur if the seal is damaged
or incorrectly fitted.
3
Turn the blade unit upside down. Lower it into the
jar, blades down.
4
Screw the blade unit onto the jar until finger tight
cr
. Refer to the graphics on the underside of the
blade unit as follows:
- unlocked position
- locked position
11
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood KHH322WH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood KHH322WH in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info