649644
24
Zoom out
Zoom in
Previous page
1/36
Next page
24
Operation
starting a wash cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back. It is recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Press the
Power button.
5. Press the P button to select the wash cycle programme based on the loading and soil
requirements. Please refer to the section Wash Cycle Table.
6. The programme indicator will light up for the selected programme.
7. Close the dishwasher door. A click should be heard when the door is closed correctly. Do not
slam the door.
8. The washing cycle will begin shortly.
changing a programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press and hold the P button for 3 seconds to cancel
the programme. You can then select the required new programme and close the door. The unit
will start the new washing cycle shortly.
4. The display window shows the state of the dishwasher.
a. “--:--” means the unit is on stand by mode.
b. “H:MM” and not flashing means the unit is on pause.
c. “H:MM” and flashing means the unit is running.
at the end of a programme
At the end of a programme, the dishwasher will beep.
If you open the dishwasher’s door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after 10 seconds. However, if the
door is not closed correctly after 1 minute, the dishwasher will beep at 1 minute intervals.
The condensation strip helps to prevent the risk of steam damage to the worktop edging
above the dishwasher, it is advisable to leave the door closed until you are ready to unload
the crockery. However, you can also open the dishwasher door fully and wait until the
dishes and crockery are cool enough to unload. Do not leave the door only partially open.
KDW60X13_IB_130307_Shaun.indd 24 07/03/2013 2:45 PM
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood KDW60X13 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood KDW60X13 in the language / languages: English as an attachment in your email.

The manual is 4,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info