159527
23
Zoom out
Zoom in
Previous page
1/84
Next page
23
Basic section
Playback of tape
To wind tape at high speed
÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
To fast wind in
direction \
To fast wind in
direction |
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." ON
(TAPE equalizer is used)
2 "TAPE EQ." OFF
(TAPE equalizer is not used)
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the re-
cording condition of the tape.
Selection of reverse mode
To stop playback
1 Select "TAPE RVS. ?".
2 Select.
3 Set it.
1 "
" : (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and then
the tape stops.
3 " " : (ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides.)
(The initial setting is "
"(REVERSE))
1
TUNING
UP
1
TUNING
DOWN
TAPE EQ.
STOP
AUTO/MONO
7
volume / multi control
set
/
demo
menu
set
/
demo
volume / multi control
\
\
\
\
(Press the set/demo key while the "?" mark is
blinking)
Remote control unit only
Main unit only
The tape counter is set to "0000" when a cas-
sette tape is loaded. By writing down the
counter reading in case you want to interrupt
recording (playback) in the middle of the tape,
the memo will be helpful as a reference for lo-
cating the same position when continuing the
recording (playback) the next time. The tape
counter figure decrements during recording or
playback of the back side (while the 2 tape
transport indicator is lit). To set the tape counter
to "0000", open the cassette holder once. Then
the counter will be reset.
A tip for use of the tape counter
Tape counter display
1 Clock display
2 Tape counter
The displayed information is switched every time the TIME DISPLAY key is pressed.
Remote control unit only
TIME DISPLAY
÷
PTY
÷
TIME DISPLAY
or
(For other countries)
(For U.K. and Europe)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood hm 383 md at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood hm 383 md in the language / languages: English as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info