706648

Kenwood FDM313 Manual

8
Zoom out
Zoom in
Previous page
1/212
Next page
5
C Standard Attachments
(6
Knife blade
(7
Dough tool
(8
Dual whisk
(9
4mm slicing/grating disc
(:
2mm slicing/grating disc
)1
Extra fine grating disc
Attachments
Not all of the attachments listed below may be
included with your food processor. Attachments
are dependent upon the model variant. Refer
to ‘service and customer care’ section for
information on how to buy an attachment not
included in pack.
D Optional Attachments
)2
Citrus juicer (if supplied)
)3
Mini chopper/mill (if supplied)
)4
Grinding mill (if supplied)
)5
Blend-Xtract 2GO (if supplied)
To Use Your Food Processor
Illustrations
–
1 Fit the detachable drive shaft onto the power
unit.
2 Then fit the bowl by aligning the
on the
bowl with the on the power unit, turn
clockwise until it locks .
3 Fit an attachment over the bowl drive shaft.
O
Always fit the bowl and attachment onto the
processor before adding ingredients.
4 Fit the lid - ensuring the top of the drive
shaft/tool locates into the centre of the lid.
O
Do not use the lid to operate the processor,
always use the on/off speed control.
5 Plug in, switch on and select a speed. (Refer
to the recommended usage chart).
O
The processor will not operate if the bowl
or lid are not fitted correctly into the
interlock. Check that the feed tube and
bowl handle are situated to the right front
hand corner.
O
Use the pulse (P) for short bursts. The pulse
will operate for as long as the control is held
in position.
6 Reverse the above procedure to remove the
lid, attachments and bowl.
O
Always switch off and unplug before
removing the lid.
Important
O
Your processor is not suitable for crushing
or grinding coffee beans, or converting
granulated sugar to caster sugar.
O
When adding almond essence or flavouring
to mixtures avoid contact with the plastic as
this may result in permanent marking.
Weighing Function
Illustration
Your food processor is fitted with a built in
weighing function to allow ingredients to be
weighed straight into the bowl or blender goblet.
O
The Maximum weighing capacity is 3kg.
To Use The Weighing Function
1 Always fit the bowl, detachable drive shaft
and attachment or blender goblet onto the
power unit before adding ingredients.
2 Plug in – the display screen will remain blank.
3 Press the ON/ZERO button once and the
display screen will light up.
4 Press the (kg/lb) button to select either
grams or ounces. The display will default to
kg/g when first switched on.
O
The unit weighs in 1g increments and
teaspoon/tablespoon measures are
recommended for weighing small quantities.
O
To zero press the ON/ZERO button once.
5 Weigh the required ingredients straight into
the bowl or goblet.
6 After all the ingredients are weighed fit the lid
and select a speed to operate the processor.
O
The weight of any additional ingredients
added down the feed tube whilst the
processor is running will not be shown on the
display screen.
O
The display screen can be turned off manually
by pressing and holding down the ON/ZERO
button for a few seconds.
Refer to the troubleshooting guide if you
experience any problems with operating the
weighing function.
Weighing Tray
A removable weighing tray is supplied for
weighing ingredients without the bowl or
blender.
To use, place the tray on top of the power unit
and turn clockwise to secure. Then follow steps 2
to 4 under ‘To Use The Weighing Function’.
To remove, rotate the tray anti-clockwise and lift
off.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood FDM313 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood FDM313 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info