672783
9
Zoom out
Zoom in
Previous page
1/48
Next page
9
4. Perform the cord wiring work.
Refer to "How to Wire" and then
perform the wiring work.(P.10)
5. Adjust the installation angle of
the device and then fix the device
in place.
Turn the angle adjustment knob
clockwise before adjustment. Adjust
the sky portion and the road portion
to 50:50 as shown in the picture below.
After adjusting the installation angle,
turn the angle adjustment knob of the
adjustment bracket counterclockwise
to fix the device in place.
Adjustment example
Angle adjustment knob
Windshield
Rear-view mirror
6. Adjusting the Settings to Match
the Vehicle
Settings are required to use the driving
support function.(P.16) The driving
support function will not work without
configuring these settings properly.
Configure the Dashboard camera on
the receiver on which the device is
connected. For connection information,
refer to the instructions supplied with
that receiver.
Recommended installation position
Install the device in a position where it will not block the front view of the driver
(position where hidden by the rear-view mirror).
Install the device so that it is within the wiping range of the wiper.
Mounting the device to the center of the windshield behind the rear-view mirror will
facilitate optimal video recording.
Windshield
Ceramic part
CAUTION
When passing the power cord through the front pillar or another part, observe the
following points when performing the wiring work.
Wire the power cord farther forward or farther rearward than the airbag so that it does not
interfere with the airbag.
In the case of a vehicle in which the front pillar cover is fixed in place with special clips or the like,
the clips may need to be replaced after you remove the front pillar cover. For how to remove the
front pillar cover, the availability of replacement parts, and other information, contact the vehicle
dealer.
Fix the power cord in place with commercially available soft tape or the like so that it does not
interfere with driving.
Double-sided tape
Inside
vehicle
Front pillar
cover
Clip
Airbag
Front pillar
Power cord1
Soft tape*
Rear-view mirror
Power cord1
*Fix the power cord in place with commercially available
soft tape or the like.
Outside
vehicle
Example of Mounting
DRV-N520W_EN301.indd 9 2017/03/08 14:05
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood DRV-N520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood DRV-N520 in the language / languages: English as an attachment in your email.

The manual is 2,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood DRV-N520

Kenwood DRV-N520 User Manual - German, Dutch - 88 pages

Kenwood DRV-N520 User Manual - French, Italian - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info