511077
67
Zoom out
Zoom in
Previous page
1/76
Next page
132 133
Return to the Top page
Troubleshooting
Return to the Top page
Troubleshooting
Problems and Solutions
If any trouble occurs, first check the following table for possible problems.
• Some functions of this unit may be disabled by some settings made on this unit.
• What might seem to be a malfunction in your unit may just be the result of slight misoperation
or miswiring.
Ñ
About settings
Problem Reason Solution
•Cannotsetupthesubwoofer.
•Cannotsetupsubwooferphase.
•Nooutputfromthesubwoofer.
•Cannotsetupthelowpassfilter.
•Cannotsetupthehighpass
filter.
Subwooferisnotset
toon.
Setthesubwoofertoon.
SeeSpeaker setup (P.118).
Thedualzonefunction
isenabled.
Setthedualzonefunctiontooff.
SeeZone Control (P.125).
•Cannotselecttheoutput
destinationofthesubsourcein
thedualzone.
•Cannotadjustthevolumeofthe
rearspeakers.
Thedualzonefunction
isdisabled.
Setthedualzonefunctiontoon.
SeeZone Control (P.125).
•Cannotsetuptheequalizer.
•Cannotsetupthecrossover
network.
Thedualzonefunction
isenabled.
Setthedualzonefunctiontooff.
SeeZone Control (P.125).
“DSPSelectissetto
“Bypass”.
Set“DSPSelecttoThrough.
SeeDSP select (P.121).
Ñ
About audio operations
Problem Reason Solution
Radioreceptionispoor. Thecarantennaisnot
extended.
Pullouttheantennaalltheway.
Theantennacontrol
wireisnotconnected.
Connectthewirecorrectly.
See“ConnectionintheQuickStartGuide.
Cannotplayaudiofilesstoredin
adisc.
“CDRead”issetto“2”.
Set“CDRead”to“1”.
SeeDisc setup (P.61).
Cannotselectafolder. Therandomplay
functionisenabled.
Turnofftherandomfunction.
Cannotperformrepeatplay
duringVCDplayback.
ThePBCfunctionis
enabled.
TurnoffthePBCfunction.
Thespecifieddiscdoesnotplay,
butanotheroneplaysinstead.
Thediscisquitedirty.
Cleanthedisc.
SeePrecautions on handling discs
(P.4).
Thediscisseverely
scratched.
Tryanotherdiscinstead.
ñ
Troubleshooting
Problem Reason Solution
Thesoundskipswhenanaudio
fileisbeingplayed.
Thediscisscratched
ordirty.
Cleanthedisc.
SeePrecautions on handling discs
(P.4).
Therecording
conditionisbad.
Recordthefileagainoruseanotherdisc.
Ñ
Other
Problem Reason Solution
TheTouchSensorTonedoesn’t
sound.
Thepreoutjackisbeing
used.
TheTouchSensorTonecannotbeoutput
fromthepreoutjack.
Error Messages
When you fail to operate the unit correctly, the cause of the failure appears as the message on
the screen.
Error Message Cause Solution
Protect Protectivecircuithasbeenactivated
becauseaspeakercordhasshorted
orithascomeincontactwiththe
carchassis.
Wireorinsulatethespeakercordas
appropriateandthenpressthe<Reset>
button(P.135).
HotError Whentheinternaltemperatureof
thisunitrisesto60°Cormore,the
protectioncircuitisactivatedand
youmaynotbeabletooperate
theunit.
Usetheunitagainafterreducingthe
temperatureoftheunit.
MechaError Thediscplayerismalfunctioning. Ejectthediscandtryinsertingitagain.Contact
theKenwooddealerifthisindicatorcontinues
blinkingorthedisccannotbeejected.
DiscError Anunplayablediscisinserted.
Changethedisc.
SeePlayable Media and Files (P.136).
ReadError Thediscisquitedirty.
Cleanthedisc.
SeePrecautions on handling discs (P.4).
Discisupsidedown. Loadthediscwiththelabeledsideup.
RegionCode
Error
Thediscyouwantedtoplayhasa
regioncodethatcannotbeplayed
withthisunit.
SeeRegion Codes in the World (P.141)or
tryanotherdisc.
ParentalLevel
Error
Thediscyouwantedtoplayhasa
higherlevelthantheparentallevel
youset.
Settheparentallevel.
SeeParental level (P.61).
Error07–67 Theunitisnotoperatingcorrectly
duetosomereasonorother.
Pushtheunit’sResetbutton.Ifthe“Error
07−67”messagedoesnotdisappear,seeyour
nearestKenwooddealer.
NoDevice(USB
device)
TheUSBdeviceisselectedasa
sourcealthoughnoUSBdeviceis
connected.
Changethesourcetoanysourceotherthan
USB/iPod.ConnectaUSBdevice,andchange
thesourcetoUSBagain.
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood DNN9230DAB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood DNN9230DAB in the language / languages: English as an attachment in your email.

The manual is 17,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood DNN9230DAB

Kenwood DNN9230DAB User Manual - English - 36 pages

Kenwood DNN9230DAB User Manual - German - 36 pages

Kenwood DNN9230DAB User Manual - German - 76 pages

Kenwood DNN9230DAB User Manual - Dutch - 36 pages

Kenwood DNN9230DAB User Manual - Dutch - 76 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info