465319
4
Zoom out
Zoom in
Previous page
1/13
Next page
6
C-414 English
7
Connections
¤
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
re hazard (Main unit and AC adapter).
Do not place a cloth on the system or place it on a carpet
or cushion.
Do not use the system in a poorly ventilated place.
Do not place any objects impairing heat radiation onto
the top of the unit.
Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm
¤
CAUTION
The power in this equipment will not be completely cut off
from the wall outlet when the standby switch is turned off.
Install the equipment so that the wall outlet is easily
accessible and, in case of emergency, immediately unplug
the power plug from the wall outlet.
Mains plug is used as the disconnect device, It shall remain
readily operable and should not be obstructed during
intended use.
AM loop antenna
FM indoor antenna
iPod applied part
Right speaker
Left speaker
Connecting the FM antenna
1 Connect the lead to the [FM 75Ω] terminal.
2 Find the location that gives the best
reception.
3 Secure the antenna as high up as possible.
The antenna supplied with the system is a basic antenna
for indoor use. For stable signal reception, the use of an
outdoor antenna (commercially available) is recommended.
Disconnect the indoor antenna first before connecting an
outdoor antenna.
¤
CAUTION
Since antenna installation necessitates skill and experience,
always consult your dealer before installation. The antenna
should be placed at a distance from the power distribution
wires. Otherwise, an electric shock accident may occur if the
antenna falls down.
Connecting the AM antenna
1 Connect the AM antenna cord to the [AM] and [HGND]
terminals.
2 Setup the antenna in the position and the direction to be
able to receive AM broadcast.
The antenna supplied with the system is for indoor use. Place
it as far away as possible from the system, your TV set, the
speaker cords, AC adapter and the power cord, and point it in
the direction that provides the best reception.
Connecting the iPod applied part
1 Connect the iPod applied part to iPod applied part
connector
2 Insert the Dock adapter into unit.
3 Connect your iPod/iPhone.
To remove Dock adapter
Insert a thin object such as the tip of a flat-blade screwdriver
into the slit on the dock adapter and lift it to remove.
Connect an iPod dock adapter, which is provided with your
iPod/iPhone or commercially available in iPod dealers, to
the iPod dock of this unit. Note that the iPod adapter is not
provided with this unit.
See page 9 for the supported iPod/iPhone models.
To AC wall outlet
Insert the plug firmly all the way
into the AC wall outlet.
To TV with video (composite)
input terminal
Video cord
Power cord
Two types of power cords
are provided. Select the one
designed for the country in
which this unit is used.
AC adapter
Use the AC adapter (AC-
18335A) provided with this
product.
Connect the audio output of the VCR, etc.
to the [AUX IN] terminals on the rear of the
main unit.
Connect a subwoofer (SW-40HT (separately available),
etc.) to the [SUB WOOFER PRE OUT] terminal on the rear
of the main unit.
FM
75Ω
FM
75Ω
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood C-414 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood C-414 in the language / languages: English as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood C-414

Kenwood C-414 User Manual - German - 24 pages

Kenwood C-414 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info