465311
50
Zoom out
Zoom in
Previous page
1/64
Next page
50
English
Troubleshooting Guide
If a fault occurs, run through the table below before taking your receiver for repair.
If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult
your dealer. Under no circumstances should you attempt to repair the unit yourself. This could void the warranty.
REMOTE CONTROL UNIT
PROBLEM POSSIBLE CAUSE REMEDY
No operation
Batteries are not loaded or exhausted.
The remote sensor is obstructed.
Replace the batteries.
Remove the obstacle.
MAIN UNIT
[AMPLIFIER SECTION]
PROBLEM POSSIBLE CAUSE REMEDY
No power
The AC input cord is disconnected.
Poor connection at AC wall outlet or the outlet is
inactive.
Connect cord securely.
Check the outlet using a lamp or another appliance.
No sound
The speaker cords are disconnected.
The master volume is adjusted too low.
The MUTE button on the remote control is
pressed to ON.
Incorrect selection of input source.
Incorrect connections between the components.
Check the speaker connections.
Adjust the master volume.
Press the MUTE button to cancel the muting effect.
Select the desired input source correctly.
Make connections correctly.
Noise or distorted sound
Poor connections. Check the connections and connect all cords
securely.
No sound from the surround
speakers
Surround mode is switched off (stereo mode).
Master volume and surround level are too low.
Monaural source is used.
Surround speaker setting is “NO”.
Select a surround mode.
Adjust master volume and surround level.
Select a stereo or surround source.
Select the desired surround speaker setting.
No sound from the center
speaker
Stereo mode, etc is selected.
Center speaker setting is “NO”.
Master volume and center level are too low.
Select the desired surround mode.
Select the desired center speaker setting.
Adjust master volume and center level.
No sound from the surround
back speakers
The input signal format or the current surround
mode cannot support the 7.1(or 6.1) surround.
Master volume and surround back level are too
low.
Surround back speaker setting is “NO”.
Under the proper situations, perform the 7.1(or 6.1)
surround playback. (For details, refer to “ENJOYING
SURROUND SOUND” on page 17.)
Adjust master volume and surround back level.
Select the desired surround back speaker setting.
[TUNER SECTION]
PROBLEM POSSIBLE CAUSE REMEDY
Station cannot be received
No antenna is connected.
The desired station frequency is not tuned in.
The antenna is in wrong position.
Connect an antenna.
Tune in the desired station frequency.
Move the antenna and retry tuning.
Preset stations cannot be
received
An incorrect station frequency has been
memorized.
The memorized stations are cleared.
Memorize the correct station frequency.
Memorize the stations again.
Poor FM reception
No antenna is connected.
The antenna is not positioned for the best
reception.
Connect an antenna.
Change the position of the antenna.
BDR-A7_EN_CS3.indb 50BDR-A7_EN_CS3.indb 50 11.3.10 6:59:43 PM11.3.10 6:59:43 PM
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood BDR-A7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood BDR-A7 in the language / languages: English as an attachment in your email.

The manual is 9,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood BDR-A7

Kenwood BDR-A7 User Manual - German - 58 pages

Kenwood BDR-A7 User Manual - Dutch - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info