686273
11
Zoom out
Zoom in
Previous page
1/18
Next page
EN
Welding process selector, MMA / TIG
Switch is used for selecting either MMA or TIG welding, depending on
welding target.
VRD: When you have switched the unit to TIG welding, VRD is constantly
active, thus reducing terminal voltage to 30 V. This facilitates arc cut-o when
you stop welding.
Regulating welding current
Welding current rate is regulated steplessly with an adjusting potentiometer.
Signal light for overheating
A yellow signal light of overheating is lit, when thermostat has tripped due
to the unit’s overheating. Fan will cool the unit and after the signal light goes
o, the unit is again ready for welding.
3.3 WELDING SELECTIONS
3.3.1 Manual Metal Arc welding (MMA)
Select welding parameters according to ller manufacturers
recommendations.
1. Select polarity (+ or -) of welding current cable and return current cable
according to ller.
2. Select MMA welding with the switch
.
3. Select suitable welding current by adjusting potentiometer.
3.3.2 DC TIG welding
Select welding parameters according to ller manufacturers
recommendations.
1. Connect TIG torch to - pole and earth cable to + pole
2. Select TIG welding with the switch
.
3. Select suitable welding current by adjusting potentiometer.
9
Minarc 150, 151 / © Kemppi Oy / 1117
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi Minarc 150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi Minarc 150 in the language / languages: English, German, Dutch, Danish, French, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info