686409
53
Zoom out
Zoom in
Previous page
1/61
Next page
53
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
5.5 Checking machine setup during booting
1. Master RCM3209 Set Fail Master Rabbit is RCM3200 in controller; change and try again.
2. Master RCM3200 Set Fail Master Rabbit is RCM3209 in controller; change and try again.
3. Not applicable
4. Not applicable
5. Wrong S2 BEMF Driver board Remote conguration is BEMF & ENCODER; change and try again.
6. Wrong S2 BEMF Driver board Remote conguration is ENCODER; change and try again.
7. Wrong S2 BEMF & ENCODER Driver board Remote conguration is BEMF; change and try again.
8. Wrong S2 ENCODER Driver board Remote conguration is BEMF; change and try again.
9. Data Load Failure Check and set weld counter.
10. Data Load Failure Language was reset to English; reselect language.
11. Data Load Failure Calibration record was reset; contact Kemppi for support.
12. Data Load Failure Calibration was reset; run travel and wire calibration again.
13. Data Load Failure Test mode, unit or print set was reset; go to Option and Print Weld to
check again.
14. Default Head Change The default weld head was reset to D Head; press Next to continue.
15. Data Load Failure Machine SN was reset to default; contact Kemppi for support.
16. Data Load Failure Machine Data is reset to default; contact Kemppi for support.
17. Weld Counter Failure Reboot machine and try again.
18. Wrong Arc Strike Method Reboot machine and try again.
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 TIG Orbital System 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 TIG Orbital System 300 in the language / languages: English as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info