686408

Kemppi A7 TIG Orbital System 150 Manual

14
Zoom out
Zoom in
Previous page
1/48
Next page
14
A7 TIG Orbital System 150© Kemppi Oy 2016 1615
OPERATING MANUAL
3.3 Electrode sharpeners
Ultima – TIG – cut NEUTRIX
Use sharpener to sharpen the electrodes, to cut them to
correct length, and to help gather and recycle welding
dust.
Desktop model (recommended) allows more precise
lengths. It recycles dust into liquid instead of air. You can
also use a hand-held model. Only sharpening is possible
with the hand-held model, not accurately cutting to
length.
You can obtain a faster and more uniform grinding result
compared to manual grinding with an optional auto-grind
device.
Tungsten is the most suitable material for welding
electrodes but it is hazardous as waste and when breathed.
3.4 Filling water cooler with coolant
You can ll the water tanks with normal tap water. However,
the degree of water purity as well as the temperature of
the environment determine if you need to apply additives
and/or otherwise take care of the water supply.
When employing TIG system at temperatures below
+8 °C, add an anti-freeze medium.
1. Fill the water tank with 3.5 liters of Kemppi torch
coolant uid or equivalent (Monopropylenglycol).
2. Use max. 40 % of coolant uid added to water. This
will provide freezing protection to ‐25 °C.
Do not use distilled or demineralized water. Zinc
deciency causes corrosion and a risk of leakage.
Even if the temperature stays above +8 °C, use a
small quantity (ca. 10 %) of anti-freeze additive. It prevents
adverse algal growth in warm water.
The amount of cooling uid required depends on the cable
length of the weld head. Normally, 3.5 litres is sucient.
Check the level of coolant after several minutes of rst
turning on power to top o the coolant level as required.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 TIG Orbital System 150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 TIG Orbital System 150 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info