686369
35
Zoom out
Zoom in
Previous page
1/66
Next page
35
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
5.4 Inputs and outputs
If you have an I/O device connected to the system, it must
be congured by using the Web UI. Inputs and outputs
are o by default. Select the desired inputs and outputs
on and congure them according to their use. The inputs
are read and outputs written by using the digital robot
interface.
5.4.1 Inputs
Input 1–8
Set the inputs 1–8 ON or OFF. When an input is set on, other
options appear below. Congure the input by selecting
the switch type, switching level, and error options.
Switch type
Indicate the type of the switch used in your input. If you are
using an opening-action switch, select OPENING, and for
a closing-action switch select CLOSING. See Subsection
3.14.1, “Inputs” for more information.
Line level
Set the level of the input line. If you have connected the
input switch between pins 1 and 2, select 0 V. Otherwise,
if you have connected the switch between pins 2 and
3, select 24 V. See Subsection 3.14.1, “Inputs” for more
information.
Error triggering
An input can trig a warning or an error when activated.
If you want to enable error triggering, select WARNING
or ERROR according to your requirements. Set the error
triggering OFF for an ordinary input signal.
5.4.2 Outputs
Output 1–8
Set the outputs 1–8 ON or OFF by the means of hardware
installation. When an output is set on, other options
appear below. Congure the output by selecting polarity
for the output signal.
Polarity
Set the output polarity to LOW-ACTIVE if you want a logic
‘0’ to active the output, or HIGH-ACTIVE, if you want a logic
‘1’ to activate the output. When the output is active, it
actively pulls the signal down. In passive state the output
is pulled up by a resistor.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info