686368

Kemppi A7 MIG Power Source 450 Manual

55
Zoom out
Zoom in
Previous page
1/67
Next page
55
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
4.10.3 Gas mixture setup
Knowing the exact mixture of the shielding gas is necessary for precise gas ow
measurement. The gas ow sensor unit supports ow measurement for any mixture of
the six base gases, including pure base gases. The mixtures are set up by specifying the
percentage of each gas in the mixture.
Recongure the mixture every time when the type of the shielding gas is changed.
The percentage of Argon is changed automatically when adjusting other gases, the
total percentage being always 100 %. For example, if Carbon dioxide is increased from 0 to
18 %, Argon is changed automatically from 100 to 82 %. This applies for Ar+18CO₂ gas. If
Carbon dioxide is increased to 100 %, Argon is decreased to 0 %. This applies for pure CO₂
gas, etc.
Setup panel
Go to the Main menu > System cong menu > Gas sensor menu > Gas mixture menu.
Navigate through the gas parameters and adjust their percentage in the mixture by
turning the control knob, according to the shielding gas in use. Press the Save button to
save the changes.
Web user interface
Go to the Welding settings > Welding system > Gas sensor settings and adjust the gases
by using sliders, or by clicking on the value and typing a new value. A pop-up bar with
Save and Reset changes buttons will appear at the bottom. Press the Save button in the
dialog to save the settings.
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Power Source 450 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Power Source 450 in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info