738043
10
Zoom out
Zoom in
Previous page
1/24
Next page
M3i INDOOR GROUP CYCLE 10
Prepare Base and Main Frame.
(a) Release the Computer Display from the packing
material and remove the Mount Screw using a #2 Phillips
Screwdriver.
(a) Slide the Computer Mount up and under the Mount
Tabs. Align the screw holes and install the Mount Screw
(removed in Step 3) using a #2 Phillips Screwdriver.
(b) Coil the Communication Wire into the Computer
Mount Cavity. Avoid pulling/pinching the Communication
Wire.
(b) Remove the two screws along the side of the Sweat
Guard (#2 Phillips Screwdriver). Next, slide the Mount
Cap (Item H) into position. Install with the two original
screws.
Pull Caps off Base Studs
Mount Screw
Communication
Wire
Mount Screw
Screws
Mount Tabs
HOW TO ASSEMBLE THE M3i BIKE
1
3
(a) Position the front of the Main Frame facing the
Transport Wheels, then carefully lower the Main Frame
onto the Base over the Base Studs.
(b) Install one Washer and one Acorn Nut (Items B and A)
onto each Base Stud. Tighten Acorn Nuts using a 16 mm
(5/8 inch) Open-end Wrench. Torque to 35 ft-lbs (47 Nm)
using a 16 mm (5/8 inch) Crowfoot and Torque Wrench.
2
4
REAR
FRONT
Mount Cover
Transport Wheels
Computer Display Computer Mount
A
B
If present, release Shipping
Board from Main Frame
(Tool: 1/2-inch Wrench)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keiser M3i - Indoor Group Cycle at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keiser M3i - Indoor Group Cycle in the language / languages: English as an attachment in your email.

The manual is 9,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info