The bass boost control is intended to adjust the response of the subwoofer to compensate for room conditions and user preferences. Boost is switchable
between 0, +6 and +12dB at around 40Hz.
Phase Control
The phase control will normally be set at 0° but more output level can sometimes be
achieved in the 180° position, particularly when the subwoofer is far away from the
satellite speakers.
PLEASE NOTE:
Volume Control
Volume control is implemented in the source equipment.
Auto/Manual Switch
In Auto mode the unit will remain in standby until a signal is sensed.
In Manual mode the unit will remain on even when no signal is present.
ADJUSTING THE CONTROLS
Realce de graves
El control de realce de graves permite ajustar la respuesta del subwoofer para compensar las condiciones de la sala y las preferencias del usuario. El realce se
puede poner a 0, +6 y +12 dB en torno a 40Hz.
Controllo di fase
El Controllo di fase debe estar normalmente en 0˚, pero algunas veces se puede obtener
un mayor nivel de salida en la posición de 180˚, especialmente cuando el altavoz de
graves esta alejado de los altavoces satélite.
ATENCI N:
Control de Volumen
El control de volumen se implementa en el equipo fuente.
Comuntador Auto/Manual
En modo Auto la unidad quedará a la espera hasta detectar una señal.
En modo Manual la unidad permanecerá encendida incluso en ausencia de señal.
Bass Boost
La fonction “bass Boost”permet d’adapter la réponse au local ou aux préférences personnelles. Les basses peuvent etre “poussées” pas par pas, 0,+6 et +12dB a
+/- 40Hz
Contrôle de phase
Le contrôle de phase sera normalement positionné sur 0°. Un niveau plus élevé de
sortie peut toutefois être obtenu en position 180°, et ce plus particulièrement
lorsque le subwoofer est éloigné des haut-parleurs satellites.
REMARQUE:
Controle de volume.
Le volume est controlé par l’amplificateur
Auto/Manual Schalter.
Im Manual Mode bleibt das Gerät eingeschaltet, auch wenn kein Signal empfangen wird.
Bassanhebung
Die Einstellung der Bassanhebung erlaubt die Anpassung des Subwoofers an die Bedingungen des Raums und Ihrem personlichen Geschmack.
Die Anhebung ist schaltbar in folgenden Stufen: 0 dB, +6 dB und +12 dB bei etwa 40 Hz.
Phasensteurung
Der Phasensteurung wird normalerweise auf 0° eingestellt. Allerdings kann manchmal
in der Position 180° ein höherer Ausgangspegel erzielt werden, insbesondere, wenn
der Subwoofer weit von den Satellitenlautsprechern entfernt ist.
BITTE BEACHTEN:
Lautst rkeregelung
Die Lautstärke wird vom angeschlossenen Verstärker/Prozessor geregelt. Im Auto Mode bleibt der Subwoofer in Stand-By, bis ein Signal empfangen wird.
Interrupteur manuel/auto.
E
Im Manual Mode bleibt das Gerat eingeschaltet, auch wenn kein Signal
empfangen wird. Pegeleinstellung uberprufen und ggf, korrigieren.
Bass Boost
Mediante il selettore “bass boost” è possibile apportare piccole enfasi nella risposta in frequenza del sub-woofer, per compensare differenti situazioni ambientali o
per preferenze personali. Le variazioni possibili sono +6 e +12 dB a circa 40 Hz.
Interruttore di fase
In genere l’interruttore di fase viene impostato a 0° ma a volte si ottiene un maggior
livello d’uscita nella posizione a 180°, particolarmente se il subwoofer è molto
distante dagli altoparlanti secondari.
NOTA:
Controllo del volume
La regolazione del volume si effettua dall’unità di controllo.
Commutatore Auto/Manual
Auto: il sub-woofer rimane in standby, e si attiva quando riceve un segnale.
Manual: il sub-woofer resta sempre acceso, anche in assenza di segnale.
(F) Réglage des commandes (D) Einstellen der Bedienungselemente (I) regolazione dei comandi (ES) Ajuste de los controles (P) Ajuste dos comandos
(NL) bediening van de regelaars (DK) Justering af betjeningsknapperne (CN) 调节控制
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for KEF HTB2SE at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of KEF HTB2SE in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.
The manual is 2,5 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
