771566
11
Zoom out
Zoom in
Previous page
1/20
Next page
7
Table 4-3 Code and Denitions
Operation lamp Flashing
times
Show on central-
ized controller
Explanation
/ / Unit is ON
/ / Unit is OFF
E2 Indoor temperature sensor
error
4E5(new protocol)
EF(old protocol)
Outdoor temperature sensor
error
6 E7 EEPROM error
8 E6 DC fan motor error
10 OFF LINE Without address
12 E1 Communication error with
ODU
14 Ip address Conict
16 EU error with sensor board
18 FC error with CO2 sensor
E9 wire controller communica-
tion failure
Ed Outdoor unit failure
NOTE: ●:Light ; ○:Extinguish ; :Quick ash
Table 4-4 Terminal Denition
CODE CN8 CN9 CN32 CN33 CN7 CN3 CN4 CN21
NAME P Q E X Y E Modbus RTU D1D2E X1X2 Indoor temp. Sensor Outdoor temp. Sensor PRO
Dry contact
(In put)
CN31 Inlet air pre-heat Signal
CN16 Force to exhaust air mode
CN26 Remote ON/OFF
Dry contact
(Out put)
CN14 Signal for ventilation fan
CN15 Alarm
CN20 Signal for inlet air Pre-heat
Communication wiring between the indoor and outdoor units
The KRE and outdoor units communicate via the RS485 serial port.
The communication wiring between the KRE and outdoor units should be connected one unit after another in a daisy chain from the out-
door unit to the nal KRE unit. And the shielded layer must be properly grounded, and a build-out resistor must be added to the last KRE
unit to enhance the stability of the communication system.
Incorrect wiring such as a star connection or a closed ring will cause instability of the communication system and system control anoma-
lies.
Use a three core shielded wire (greater than or equal to 0.75 mm2) for the communication wiring between the indoor and outdoor units.
Make sure the wiring is connected correctly. The connecting lead for this communication wire must come from the master outdoor unit.
All shielded wiring in the network are interconnected, and will eventually connect to earth at the same point “ ”.
P
Q
Outdoor
unit (Connect the shielded end of the shielded wire to
the electronic controller box sheet metal " " here)
Signalling line be-
tween outdoor units
Connecting the shielded
layer of the shielded wire
Only the last indoor unit requires add-
ing the build-out resistor at P and Q.
(open)
Indoor and out-
door units Com-
munication wire
Build-out
resistor
(P Q E)
(P Q E)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KRE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KRE in the language / languages: English as an attachment in your email.

The manual is 1.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info