771571
19
Zoom out
Zoom in
Previous page
1/48
Next page
Battery inspection
Gas
Liquid
Direct expansion coil
Electric board side
Kit UTA
Refrigerant connections
7 - INSTALLATION AND START UP
7.6 CONNECTION TO THE DUCTS
The ducts must be dimensioned depending on the plant and the aeraulic features of the unit fans. An incorrect
calculation of the ducting causes a loss of power or the intervention of any devices present on the plant.
It is recommended to use insulated ducts to prevent the formation of condensate and attenuate the noise level.
To prevent transmission of any machine vibrations into the environment it is recommended top lace an anti-vibration
joint between the
fan vents and the ducts. The electrical continuity must however be guaranteed between the duct and
the machine via the earth cable.
7.7 HYDRAULIC CONNECTIONS
The installation and connection operations of the hydraulic pipes are
m
perations that can compromise the good
functioning of the plant or worse, cause irreversible damage to the machine.
These operations must only be performed by specialised staff.
The units are all equipped with condensate drip tray made of galva- nized metal sheet.
The condensate drip tray has a drain with G 1/2 male.
The drain system must have a suitable siphon for preventing the un- desired entry of air into the depressurised
systems or the undesired exit of air in pressurised systems. Otherwise the condensate does not drain and it
would wet the inside of the unit with unwanted consequences.This siphon is also useful to prevent the
infiltration
m
f odours or insects.
The dimensioning of the siphons in the case of depressurised tray, must be done according to the following (fig. 7)
and table.
fig. 7
Model H [mm]
1500DX1 80
2300DX1 80
3100DX1 80
Drip tray level
IMPORTANT: IT IS PROHIBITED TO START THE UNIT IF THE FAN VENTS ARE NOT DUCTED OR
PROTECTED WITH ACCIDENT-PREVENTION MESH ACCORDING TO THE CURRENT REGULATION.
pag. 19
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KRE-3100DX1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KRE-3100DX1 in the language / languages: English as an attachment in your email.

The manual is 3.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info