771460
12
Zoom out
Zoom in
Previous page
1/20
Next page
I&O manual
10
Replacement of the heat-exchanger coil
Procedure for removal of the heat-exchanger:
1 Remove the casing (on units I and II);
2 Isolate the flow and return water pipes;
3 Disconnect the coil from the water system;
4 Remove the screws on both sides which hold the
coil to the structure of the unit;
5 Take out the heat-exchanger coil.
Fig.3-12
6 Procedure for refitting the heat-exchanger is a
reversal of the above.
DISMANTLING THE UNIT AND DISPOSAL OF
HARMFUL SUBSTANCES
PRESERVE THE ENVIRONMENT!
We care about protecting the environment. When the unit is
dismantled it is important to adhere scrupulously to the following
procedures.
The unit should only be dismantled by a firm authorized
for the disposal of scrap machinery.
The unit is composed of materials considered as
secondary raw materials and the following conditions must
be observed:
1 If the system has antifreeze as an additive, it must not be
just dumped, because it causes pollution. It should be
collected and suitably disposed of.
2 The electronic components (electrolytic condensers)
should be considered special waste, and as such they
should be delivered to a firm authorized to collect them.
3 The expanded polyurethane rubber insulation on the
pipes and the expanded polyethylene mesh, the
expanded polyurethane and sound-absorbent sponge
lining the bodywork must be removed and processed as
urban refuse.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-SE-2T-900D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-SE-2T-900D in the language / languages: English as an attachment in your email.

The manual is 1.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info