771448

Kaysun KFC-S2E-2T-800D Manual

14
Zoom out
Zoom in
Previous page
1/22
Next page
3cm/m
Make sure the drain
connector is stress-free
Base
Remove the knockout plate at the
foundation in case the water pipe
passes under the unit
knockout plate
50mm50mm
Place a drain
stopper at the
bottom of the
elbow
auxiliary drain pan
22
1
1
Casing
assembly
12
All water system coils are equipped with discharge and
drain valves.
Use a screwdriver or wrench to open and close the valve.
2) When installation is complete,
a) Remove air inside pipes.
b) Wrap the connecting pipes and all the valve body with
anti-condensation material (EPDM or PE) of no less than
10 mm thick or install auxiliary drainage equipment.
c) Pour water into the drain pan and check it all the
way until you can see water ows from the drain outlet.
Alternatively, you may check the drain channel and
remove impurities that may obstruct the ow.
d) Install the condensate drain system.
e) The condensate drain system must be properly lowered
to ensure water discharge.
Follow the steps below to set the condensate drain
system.
3) Set water storage elbow
The condensate drain system must be tted with a suitable
elbow to prevent odour penetration. Follow the steps below
to set the elbow.
The customer has to purchase the three-way valve and its
accessories (Operation and Installation Manual attached)
separately from the manufacturer.
The customer may also need to purchase the auxiliary
drain pan separately from the manufacturer if required. See
the steps below for installation of auxiliary drain pan:
4) How to change the coil from left-hand connection
to right-hand connection
Left-hand connection of the coil is adopted by default. You
can rotate the coil and change to right-hand connection.
Before installation, you should change the direction of the
coil on the ground.
Steps of changing the coil direction:
As shown in Figure 5-17, remove screws ①*2 and ②*2
and then the casing.
As shown in Figure 5-18, remove screws ①*7 to take the
drain pan out.
Then, remove screws ②*4 to take the heat exchanger
out.
Pull out the temperature sensor plug.
Rotate the coil in the direction as shown in Figure 5-18.
As shown in Figure 5-19, remove screws ①*2 to take the
electric box out.
Fasten the screws on the coil.
As shown in Figure 5-19, block the diamond-shaped
holes on the side plate (the plate without inlet and outlet
pipes) with sponge.
Reverse the direction of drain pan plug.
Re-install the electric box to the side plate without inlet
and outlet pipes.
Re-connect the wires.
Figure 5-17 Removal of casing
Figure 5-14
Figure 5-15
Figure 5-16
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-S2E-2T-800D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-S2E-2T-800D in the language / languages: English as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info