771447

Kaysun KFC-S2E-2T-500D Manual

9
Zoom out
Zoom in
Previous page
1/22
Next page
22
1
1
Casing
assembly
22
22
1
1
FanFan
Upper propeller
housing
Filter
Motor
2
2
2
2
1
1
1
1
1
1
1
Heat
exchanger
Temperature
sensor plug
Drain pan
22
1
1
Casing
assembly
Electric
control
box
1
1
07
4) If necessary, you should:
a) Remove any foreign matters that may impede air ow.
b) Remove the dust with compressed air or clean water and avoid damage to the heat exchanger.
c) Dry with compressed air.
d) Check for any impurities in the drain pipe that may impede water ow.
e) Check whether the system has air.
●Start and let the system run for several minutes.
●Stop the system.
●Open air discharge valve to remove air.
●Repeat this operation until the air is exhausted.
5) Maintain the circuits.
Check whether the power cord, electrical contacts, terminals etc. are loose or damaged.
6) If the motor needs to be replaced, follow the steps below:
a) Unplug the unit.
b) As shown in Figure 4-4, remove screws ①*2 and ②*2 and then the casing.
c) As shown in Figure 4-5, remove screws ①*2 to take the lter out. Then, remove the upper volute.
After that, remove four screws ( ②) that x the motor, to disconnect the motor cable and the main board. Then, take out the fan
and the motor.
Disassemble the fan to get the motor.
Install back the motor in reverse order.
Figure 4-4 Removal of casing Figure 4-5 Removal of lter, upper volute and motor screws
7) If the heat exchanger needs to be replaced, follow the steps below:
a) Unplug the unit.
b) Shut off the water supply.
c) As shown in Figure 4-6, remove screws ①*2 and ②*2 and then the casing.
d) Drain the coil.
e) Disassemble the inlet and outlet pipes.
f)As shown in Figure 4-7, remove screws ①*2 to remove the electric control box.
g) As shown in Figure 4-8, remove screws ①*7 to take the drain pan out. Then, remove screws ②*4 to take the heat
exchanger out.
h) Pull out the temperature sensor plug.
Install back the heat exchanger in reverse order.
Figure 4-6 Removal of casing Figure 4-7 Removing the electric control box Figure 4-8 Removal of drain pan and heat exchanger
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-S2E-2T-500D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-S2E-2T-500D in the language / languages: English as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info