771445
11
Zoom out
Zoom in
Previous page
1/22
Next page
22
1
1
Casing
assembly
1
1
1
1
2
2
11
Base
Footing
Base
Structure the square rod on the beam to set the lifting
bolts.
Directly set and use an angle steel for support.
Use embedded bolts, and pull bolts.
Wood structure
Steel framework
Suspension bolt
Suspension bolt Angle steel
for support
Knife-type
insertion piece
Sliding-type
insertion piece
Reninforced bar
Embedded bolt(hanging and
embedded bolt of piping)
09
Original concrete slasb structure
Newly set concrete slab structure
Figure 5-1
Mark the places for screws on the wall according to the unit
mounting holes or dimensions specied in Figure 5-12. The
drain pipe for condensate water must be smooth enough to
allow unobstructed water discharge.
As shown in Figure 5-2, fasten four screws ( ) into a
proper masonry structure.
Figure 5-2 Diagram for xing the unit body
The footings shown in Figure 5-3 are optional. You can
purchase them separately and install them as follows:
1. Put the footings beside the unit to be installed.
2. Place the mounting holes on the unit base into the
corresponding footing locating pin and install screws *2
and *2 to x the footing according to Figure 5-3.
Figure 5-3
3) Install the unit following the steps below in case it
is ceiling mounted.
To match the existing structure, set the screw pitch
according to the unit dimensions.
Figure 5-4 Installation of lifting bolts
Set using embedded appliances, and embedded type
of bolts.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-S2E-2T-250D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-S2E-2T-250D in the language / languages: English as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info