771450
19
Zoom out
Zoom in
Previous page
1/22
Next page
17
Refer to Maintenance Manual for troubleshooting.
1) Error code overview
If a centralized controller is used, error codes appear on the user interface. Contact the installation personnel and inform them
of the error code, unit model and serial number (you can nd the information on the nameplate of this unit).
6.2 Non-Unit Related Faults
The following fault symptoms are not caused by the unit itself:
1) Fault symptom: Fan speed is not consistent with the setting
The fan doesn’t respond to the controller. In cooling mode, when the pipe water temperature is outside the allowable range of
room temperature, the fan speed will be maintained at a low level to avoid direct exposure to hot air. In heating mode, when
the pipe water temperature reaches a certain low level, the fan speed will also be maintained at a low level to avoid direct
exposure to cold air.
2) Fault symptom: Fan direction is not consistent with the setting
The fan direction is inconsistent with the direction indicated on the user interface. Swing is a customized function. If the
customer customizes this function and the fan direction does not correspond to the set direction, this is because the unit is
controlled
3) Fault symptom: white fog from a certain unit
This may result from high humidity during cooling mode. If the interior pollution of the fan coil unit is severe, the indoor
temperature distribution may be uneven. At this time, you need to clean the inside of the unit. Ask the dealer for information on
how to clean the unit. This operation must be carried out by qualied maintenance personnel.
4) Fault symptom: dust and dirt in the unit
This may happen after the unit is used again after being left idle for a long period. This is because there is dust inside the unit. 5)
Fault symptom: odour from unit
This unit will absorb the odours of rooms, furniture, cigarettes and others, and then disperse the odours again. Odour might
occur after small animals enter the unit.
6.3 Product Data
NO. Error Name Running Indicator Fault Indicator Buzzer action Error Code
1 Error E2PROM communication
error Steady on Flashes once every
3 seconds
Buzzes 2 times
every 3 seconds E7
2 Error Room temperature sensor
port abnormal Steady on Flashes 2 times
every 3 seconds
Buzzes 2 times
every 3 seconds E2
3 Error Coil sensor (T2C) port
abnormal Steady on Flashes 3 times
every 3 seconds
Buzzes 2 times
every 3 seconds E3
4 Error Coil sensor (T2C) port
abnormal Steady on Flashes 3 times
every 3 seconds
Buzzes 2 times
every 3 seconds E4
5 Error DC motor stall fault Steady on Flashes 4 times
every 3 seconds
Buzzes 2 times
every 3 seconds E8
6 Protection Water level exceeding
warning line Blinking Flashes once every
3 seconds
Buzzes 2 times
every 3 seconds EE
7 Protection
Model protection not set
(model DIP switch not listed
in the model table)
Blinking Flashes 2 times
every 3 seconds
Buzzes 2 times
every 3 seconds PH
8 Protection Water temperature
protection Blinking Flashes 3 times
every 3 seconds
Buzzes 2 times
every 3 seconds P1
9 Protection Anti-freezing protection Blinking Flashes 4 times
every 3 seconds
Buzzes 2 times
every 3 seconds P0
10 Protection Remote shutdown Blinking Flashes 5 times
every 3 seconds
Buzzes 2 times
every 3 seconds P2
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-S2-2T-350D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-S2-2T-350D in the language / languages: English as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info