771464
6
Zoom out
Zoom in
Previous page
1/12
Next page
owner’s manual
4
Maintenance before a long stop period
(eg. at the beginning of the cold season)
Drain the water system(for all heat exchangers).
To avoid the risk of rupture due to freezing, it is advisable to
drain the water from the system at the beginning of the cold
season
Maintenance before a long stop period
(eg. at the end of the season)
Let the indoor units run in fan only operation for about half a
day in order to dry the interior of the units.
Clean air filters and casings of indoor units. Refer to "
Cleaning the air filter" for details on how to proceed and
make sure to install cleaned air filters back in the same
position.
S faceplate
air filter
net of clear air
mesh enclosure of clear air
Fig.6-1
Cleaning the air filter and net of clear air
The air filter can prevent the dust or other particulate from
going inside. In case of blockage of the filter , the working
efficiency of the air conditioner may greatly decrease .
Therefore, the filter must be cleaned once two weeks during
long time usage.
If the air conditioner is installed in a dust place, clean the the
air filter frequent.
If the accumulated dust is too heavy to be cleaned, please
replace the filter with a new one(replaceable air filter is an
optional fitting).
1
Open the faceplate, then Dismantle the air filter and net of
clear air.
2
Clean the air filter
Vacuum cleaner or pure water may be used to clean the air
filter.If the dust accumulation is too heavy , please use soft
brush and mild detergent to clean it and dry out in cool place
The air-in side should face up when using vacuum cleaner.
(Refer to Fig 6-2)
The air-in side should face down when using water.
(Refer to Fig 6-3)
3
Re-install the air filter and net of clear air.
4
Close the faceplate#$
!
!
CAUTION
Do not dry out the air filter under direct sunshine or with fire.
C faceplate
Fig.6-2
Fig.6-3
7.
FOLLOWING SYMPTOMS ARE NOT AIR
CONDITIONER TROUBLES
Symptom 1: The system does not operate
The air conditioner does not start immediately after the ON/OFF
button on the remote controller is pressed.
If the operation lamp lights, the system is in normal condition.
To prevent overloading of the compressor motor, the air
conditioner starts 3 minutes after it is turned ON.
If the operation lamp and the "PRE-DEF indicator(cooling and
heating type) or fan only indicator(cooling only type)" light, it
means you choose the heating model, When just starting, if the
compressor has not started, the indoor unit appears "anti-cold
wind" protection because of its overflow outlet temperature.
air filter
net of clear air
mesh enclosure of clear air
Symptom 2: Change into the fan mode during cooling
mode
In order to prevent the indoor evaporator frosting, the system
will change into fan mode automatically, restore to the cooling
mode after soon.
When the room temperature drops to the set temperature, the
compressor goes off and the indoor unit changes to fan mode;
when the temperature rises up, the compressor starts again. It
is same in the heating mode.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-AY-2T-250D1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-AY-2T-250D1 in the language / languages: English as an attachment in your email.

The manual is 0.99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info