550949
42
Zoom out
Zoom in
Previous page
1/515
Next page
2-14 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Throttle Bore Cleaning
Check the throttle bore for cleanliness as follows:
Remove
the throttle body assy (see Fuel System (DFI)
chapter).
Check the main throttle valves and throttle bores [A] for
carbo
n deposits by opening the main valves.
If any carbon accumulates, wipe the carbon off the throt-
tle bores and throttle valves, using a cotton pad [B] pen-
etra
ted with a high-flash point solvent. Be careful not to
remove molybdenum disulfide coat (black) [C] from the
throttle valves and the bores.
Fron
t of Throttle Body [D]
CAUTION
Do not
rub these surfaces hard and do not use a car-
buretor cleaning solution, which dam age molybde-
num disulfide coat; instead, use a high-flash point
clea
ning solution and wipe slowly.
Idle Speed Inspection
Start the engine and warm it up thoroughly.
With the engine idling, turn the handlebar to both sides.
If handlebar movement changes the idle speed, the
throttle cables may be improperly adjusted or incorrectly
routed or damaged. Be sure to correct any of these
conditions before riding (see Cable, Wire, and Hose
Routing section in the Appendix chapter).
WARNING
Operation with improperly adjusted, incorrectly
routed or damaged cables could result in an unsafe
r
iding condition.
Check idle speed.
If the idle speed is out of the specified range, adjust it.
Idle Speed
Standard: 1 100 ± 50 r/min (rpm)
Idle Speed Adjustment
Start the engine and warm it up thoroughly.
Turn the adjusting screw [A] until the idle speed is correct.
Open and close the throttle a few times to make sure that
the idle speed is within the specified range. Readjust if
necessary.
Front [B]
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kawasaki ZR 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kawasaki ZR 1000 in the language / languages: English as an attachment in your email.

The manual is 11,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info