473819
119
Zoom out
Zoom in
Previous page
1/132
Next page
119
In the event of a malfunction, rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set correctly connected by a HDMI or cinch cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem Cause Remedy
A “No signal!” warning appears
on some or all channels
Antenna signal of satellite
reception system missing or
faulty. Incorrect LNB frequencies
set in “Antenna Con guration”
menu.
Consult an antenna specialist to
have it checked and repaired as
necessary. Check the settings
in the “Settings”, “Antenna
con guration” menu, and change
them if necessary.
Remote control no longer
responding
Receiver or remote control
command set may have been
unintentionally changed
Set infrared code 1, as described
in the operating manual under
“General operating instructions”,
“Remote control code”; check
batteries
Wrong time being displayed
“Summer
Time” setting wrong.
An incorrect time was imported
from the reception signal
On “Settings” - “Date and
time” menu check “Summer
Time Enabled” and change as
necessary Use the on/off switch
to switch the receiver off from the
current channel, e.g. Das Erste
or ZDF, wait 10 seconds and
then switch it back on
The following channels cut out
or “No or bad signal!” appears:
DSF, Tele 5, HSE 24 and
Sonnenklar TV
DECT telephones operate on
the same frequency as these
channels. Interference may
occur due to inadequate level
or poor shielding of cable
Consult your antenna specialist
Troubleshooting
If the UFS 940sw has problems dissipating the hear that is generated within the unit, and there
is a risk of overheating, you will receive the display shown below on the left. Switch the receiver
off! If you do not switch the receiver off and the temperature continues to rise, you will receive the
display shown below on the right. The receiver will then automatically cut out in order to protect itself.
Check the installation location of the receiver by reference to the section “Connection and Setup”,
“Installing the UFS 940sw ...”, before you switch the unit on again.
Warning: Operating temperature of the
receiver too high. Please switch off!
Note: Operating temperature of the receiver
critical. Switching off in 7 seconds
119


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein UFS 940sw at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein UFS 940sw in the language / languages: English as an attachment in your email.

The manual is 17,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein UFS 940sw

Kathrein UFS 940sw User Manual - German - 132 pages

Kathrein UFS 940sw User Manual - Dutch - 132 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info