631833
12
Zoom out
Zoom in
Previous page
1/24
Next page
12
OPERATION
SELECTION OF THE CHANNEL TO BE MEASURED
Now the required measuring channel can be selected:
In principle there are various ways you can select the channel
1. Selection of a programme using the programme names
1.1. Select the required channel table using the “Chan.Tab” button.
1.2. The required programme name can be entered in the “Prog.Name” eld (here the programme
name is automatically completed).
2. Selection of the programme via the channel number
2.1. Select the required channel table using the “Chan.Tab” button.
2.2. The number for the required programme position can be entered using “Prog.Number”.
3. Selection of a programme using the channel
3.1. Select the required channel table using the “Chan.Tab” button.
3.2. The required channel can be selected in the “Channel” selection.
4. Selection of a programme using the frequency
4.1 Select the required channel table using the “Chan.Tab” button.
4.2 The required frequency is entered in the “Frequency” eld.
4.3 The frequency entry is automatically corrected to the correct video carrier frequency or channel
mid-frequency. You can ne tune the frequency using the “<” and “>” buttons.
If the “Couple Chan” function on the “EXTEND” menu is set to “TO STAND.”, all further settings
(Standard, Mapping, Symbol Rate etc.) are made automatically.
If you want to set these parameters individually, you must set the “Couple Chan” function on the
“EXTEND” menu to “NOT COUP.”.
SELECTION OF THE MEASUREMENT
To make a measurement after completing the setting of the channel, the related measuring instrument
can be opened using the
hard key and subsequent selection via the onscreen menu.
The following measurements and measuring instruments can be selected:
Sub-menu for settings DiSEqC
TM
, SCIF, etc.
Spectrum analyser
Constellation analyser
Pulse / re ection measurement (only for DVB-T)
Read MPEG stream, MPEG monitor
Storage oscilloscope
Summary measurement, simultaneous measurement of RF level, S/N, MER, BER, HUM and
video voltage
TV picture, videotext
Setting for the various outputs (ASI, TS parallel, video)
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein MSK 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein MSK 200 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info