473815
10
Zoom out
Zoom in
Previous page
1/68
Next page
10
Circular cutter, Ø 38 mm
Flat-bladed screwdriver for M5 screws
• Power drill
Galvanised round head screws, depending on the roof structure (Ø: 5 mm, sheet metal screws D 7981,
depending on the roof structure) or round head screws D 7985 with washers and nuts
Twist drill, Ø 2.5 or 5.5 mm
• Round le and/or emery paper
• Cleaning agent
Open-ended or ring spanners 10 and 11 mm across ats
• Knife
Cross-head screwdrivers for M3 and M5 screws
Torque wrench capacity 6 to 11 Nm
Hexagon socket key (5 mm)
Two wooden beams for supporting the turntable
REQUIRED TOOLS AND EQUIPMENT
INSTALLATION AND CONNECTION
The CAP 710 must not be carried on the satellite
dish, since this can cause the dish to distort. Keep
the CAP 710 in its cardboard box for transport on
to the vehicle roof.
Retain the original packaging, as if it is necessary
to send the unit for repair transport damage cannot
be ruled out and the manufacturer accepts no
liability for possible damage.
Loosen the six fastening screws (width A/F:
10 mm). Carefully lift the turntable off the mounting
plate and place it on the prepared wooden
supports. Make sure that the cables are not
crushed where they emerge from the underside of
the turntable.
UNPACKING AND PREPARATION
Essentially, the cable lengths of the MobiSet 3 CAP 710 components allow you a free choice of installation
location on your caravan or motor home.
However, you should take note of the following points:
Before installation, you should nd out whether the operating manual for your vehicle permits the tting
of non-vehicle-speci c parts or what requirements need to be met in order to do so.
For direct satellite reception, there should be no obstructions between the antenna and the satellite.
Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks,
air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of the
parking place for your vehicle. For interference-free satellite reception, the antenna needs a projected
free view to the South at an angle of between 0° and 75° (depending on location) to the horizontal.
SELECTING THE INSTALLATION LOCATION
The CAP 710 packaging can be opened along
both long sides. This allows easier access to the
fastening screws.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein MobiSet 3 digitaal CAP 710 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein MobiSet 3 digitaal CAP 710 in the language / languages: English as an attachment in your email.

The manual is 4,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein MobiSet 3 digitaal CAP 710

Kathrein MobiSet 3 digitaal CAP 710 User Manual - German - 68 pages

Kathrein MobiSet 3 digitaal CAP 710 User Manual - Dutch - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info