936.2066/D/0805/10.20d.e.f.esp./SKS Subject ot technical changes.
KATHREIN-Werke KG · Anton-Kathrein-Straße 1–3 · Postfach 10 04 44 · D-83004 Rosenheim · Germany · Telefon (0 80 31) 18 40 · Telefax (0 80 31) 18 43 06
Internet: http://www.kathrein.de
Installation of the clip-on mounting set
– The supplied clip-on mounting set is destined for installation of
Sat matrices on rails (clip-on set. acc. to EN 50022)
– Each matrix must be fastened with two clip-on sets
– Install the mounting rail on an even surface. Improper mounting of
the matrix (e.g. twisting of the rail on an uneven surface)
endangers secure installation of the matrix on the rail
– Place the attaching
feet into the gap in
the mounting plate
and lock the snap
hooks by applying
pressure
– Place the hooks of
the rail attachment
into the clamping rail
– Lock them into the
clamping rail by
pressure on the
matrix (arrow)
– To dismantle the matrix, press down
both releasing levers (arrow)
– Tilt the lower section of the matrix
outward
– If the releasing levers have been
accidentally pressed (without
intending to remove the matrix), the
system is unlocked
– The matrix must be tilted outward and
locked into place once more
– In order to avoid
damaging the
mounting rail when
screwing on the
earthing wire, it is
recommended to
support the matrix
behind the fixing
screw
What to do when…?
Problem Possible cause Solution
LED of the integrated power unit does not Short-circuit in horizontal circuit Check the coaxial cable
light up Overload in the horizontal circuit Reduce the load by an additional power unit,
e.g. for a pre-circuited amplifier
Matrix does not switch No control signal from the receiver Check for short-circuit free con. from the receiver to the matrix
Check the menu setting of the receiver
Matrix switches, but no matching picture Input connections are reversed Check if the connection from the LNB to the matrix is
appears correct
Overload in vertical circuit Local feeding of inadm. consumer units (e.g. inline amplifiers)
The vertical programme does not function Short circuit in vertical circuit Check the coaxial cable
Picture switch-over is too slow DiSEqC
TM
is switched on Set DiSEqC
TM
to OFF in the menu setting
of the receiver
Note:
At places where access is difficult,
the release can be effected with a screw driver
Note:
The matrix
EXR 5016 is not
suitable for
installation on rails.
