424785
16
Zoom out
Zoom in
Previous page
1/36
Next page
16 / 36
V = 0° V = -20° V = +20°
Aligning the antenna
The antenna must be exactly aligned towards the satellite in respect
of both the direction (azimuth) and also the inclination (elevation).
For multi-feed applications the antenna should be aligned towards
the satellite which is transmitting the weakest signal.
a) Adjusting the inclination (elevation)
Use the allen wrench () supplied with the parabolic antenna
to slacken the two screws on each side of the inclination scale
(elevation) on the left and right of the support.
Then adjust the inclination (elevation) – the exact elevation
angle for your location can be found in the manual for the feed
system (LNB).
When doing this, retighten rst just one of the bolts on the
inclination scale nger-tight ().
Do not slacken the upper nuts () on the
bracket – these are factory-set to a xed
tightening torque.
b) Setting the direction (azimuth)
If you yourself are unable whilst performing the adjustments to read
the results of the alignment work on an antenna meter or screen
connected to the satellite receiver, you may need an assistant for
the following steps. The precise alignment of the antenna can be
achieved only if a digital antenna meter is used. Ask your dealer
about this.
Set the satellite receiver to a known channel so that you can
check that you have really “locked on” to the desired satellite.
Now slightly loosen the wing nuts on the mast clamp ().
Twist the antenna so that it faces roughly south. Then slowly
twist the antenna about its central axis to left and right until the
best reception is obtained for the selected channel.
Then tighten the wing nuts initially just enough to prevent the
antenna turning.
Scale V angle
Direction of rotation for po-
larisation angle (PW)
Multiple feed systems (multi-feed)
To optimise the multi-feed reception, the tiltable support “H”
should be tilted to the angle “V” according to the table attached
to this document.
The polarisation angle on the respective feed system must be
set according to the following formula.
PW
NEW
= PW
TAB
- V
PW
NEW
= polarisation angle to be set
PW
TAB
= polarisation angle of the selected satellite according to
the table in the LNB user instructions
V = setting angle of the support according to the selected satellite
combination of the attached table
With the settings and the calculation, pay attention to preceding
signs!
In order to be able to tilt the support you must rst use the allen
wrench to slacken the bolt shown arrowed in the illustration on
the right.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein cas 90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein cas 90 in the language / languages: English, German as an attachment in your email.

The manual is 2,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info