631812

Kathrein CAS 075 Manual

11
Zoom out
Zoom in
Previous page
1/32
Next page
935.1524/F/1205/3.8e
Attention!
The installation work can create problems for your
health and life.
Therefore:
The mounting procedure described here demands
skills and a knowledge how the antenna behaves
when being subjected to atmospheric conditions. If
you do not have the required skills, ask a specialist
to do the installation work.
When working on the roof or near to drop away
sites, use a safety belt.
Make sure that the roof will support your weight.
Wear non-slip shoes.
Use ladders or other climbing aids that are in
perfect condition.
If passers-by can be hurt by falling objects, block
the danger area.
Watch out for overhead power lines. Getting into
contact with these means danger to life!
Never work on antenna installations during a
thunderstorm or when one is approaching.
This can put your life at risk!
5. Installation of the antenna
Make sure that the mast is in a vertical position, otherwi-
se the alignment of the antenna to the satellite can crea-
te problems.
a) Requirements for the antenna support
Only use masts or supports specially suited to be
used as antenna support. Other supports often do not
have the necessary strength required for the environ-
mental conditions.
Choose a mast that has a diameter of 48-76 mm and
a wall thickness of a least 2 mm. For mounting on the
wall, Kathrein recommands the wall supports ZAS 60,
ZAS 61, ZAS 74 or ZAS 76.
When mounting takes place on the roof, see to it that
at least one sixth of the total length of the mast is
clamped (in the example below, one sixth equals 0.7
m).
b) Several antennas mounted on a mast:
We recommend to install the antenna on the lower
part of the mast in order to keep the bending moment
on the fixing point as low as possible.
Take care that you do not exceed the max. load rating
for the mast or support given in the technical data.
If you use for your antenna system conventional
household antennas and components bought from a
specialist dealer (antenna mast with a steel quality
ST 52, a diam. of 60 mm and a wall thickness in the
fastening area of 2.5 mm – e. g. ZSH 59 from
Kathrein) and effect the installation as shown in the
example on the left, you can be sure that the max.
load is sufficiently respected.
Attention! In case your antenna array will be
different, you must calculate the windload and
bending moment acc. to DIN EN 50083-1 (or you ask
a specialist to do it for you).
FM
UHF
VHF
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein CAS 075 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein CAS 075 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 5,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info