631831

Kathrein CAP 720 - MobiSet 3 Twin Manual

12
Zoom out
Zoom in
Previous page
1/68
Next page
12
• Choose an installation position on the roof that is as horizontal as possible or only slightly sloping,
depending on the location of the vehicle, since roof inclinations greater than 5° may lead to problems
when searching for the satellite.
• To ensure secure adhesion, the height difference of the roof curve may not be more than 1 cm over a
length of 2 m, as otherwise the gap between the roof and the mounting plate would be too great to be
fi lled by the adhesive sealant.
• As the vehicle is constantly subjected to vibration loads during travel, the roof below the antenna unit
is also subject to signifi cant loads. Please note given the nature and capacity of your vehicle roof
(see also operating manual for the vehicle) that the weight of the antenna unit is approx. 9.7 kg.
In case of doubt, consult a qualifi ed dealer or your vehicle’s manufacturer.
• The roof gland provides a watertight seal through which the three connecting cables (coax cable and
power supply cable) are fed into the interior of the vehicle directly underneath the turntable. If you
prefer a different method of laying the cables, they can be run from the rear of the turntable via the
channel provided in the mounting plate. The cables must then be run along the roof of the vehicle
in a protective cable duct and through a separate HDZ 100 roof gland (neither supplied).
• The HDZ 100 roof gland is available as an accessory under part number 20410032 from specialist
dealers.
Note: Do not cut the cables short, as otherwise the proper functioning of the unit can no longer be
guaranteed.
• In the centre of the intended position of the turntable, drill the opening for the cable gland with a circular
cutter (Ø: 38 mm). Deburr the hole with a round fi le or emery paper.
• Provisionally insert the roof gland into the drilled hole (Fig. A).
Figure: A
Note: If you had previously used a Kathrein HDM140/141 fl exible satellite mast or another mast
with a diameter of 34 mm, you can continue using the existing gland hole in the roof
(if space allows).
INSTALLATION STEPS
INSTALLATION OF CABLE GLAND AND MOUNTING PLATE
INSTALLATION AND CONNECTION
O Ring Adhesive
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein CAP 720 - MobiSet 3 Twin at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein CAP 720 - MobiSet 3 Twin in the language / languages: English as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein CAP 720 - MobiSet 3 Twin

Kathrein CAP 720 - MobiSet 3 Twin User Manual - Italian - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info