631715
13
Zoom out
Zoom in
Previous page
1/56
Next page
13 of 56
5.1.3 Selecting the Installation Location
Essentially, the cable lengths and components that are supplied allow you a free choice of installation location on your
caravan or motor home.
When selecting the installation location, take note of the following points:
Before installation, nd out whether the operating manual for your vehicle permits the tting of non-vehicle-specic
parts or what requirements need to be met in order to do so.
For direct satellite reception, there should be no obstructions between the antenna and the satellite. Therefore,
make sure that the antenna is not shadowed by roof attachments such as luggage racks, air conditioning units, solar
panels, etc.
The problem of shadowing applies also when selecting a parking place for your vehicle. For interference-free satellite
reception, the antenna needs a free view to the south at an angle of between 0° and 75° (depending on location) to
the horizontal.
When selecting the installation location, take into account the range of movement of the turntable, see Chapter
10,p.35. There must not be any attachments on the roof that would obstruct this range of movement (risk of colli-
sion). To be on the safe side, keep slightly more than the required area free. This allows for an easier installation and
any subsequent dismantling.
Choose an installation position on the roof that is as horizontal as possible or only slightly sloping, depending on the
location of the vehicle, since roof inclinations greater than 5° may lead to problems when searching for the satellite.
To ensure secure adhesion, the height difference of the roof curve must not be more than 1cm over a length of 2m,
as otherwise the gap between the roof and the mounting plate would be too great to be lled by the adhesive sealant.
As the vehicle is constantly subjected to vibration loads during travel, the roof below the antenna unit is also subject
to signicant loads. Please note, given the nature and capacity of your vehicle roof, that the weight of the antenna
unit is approx. 9.7 kg, see the operating manual for the vehicle. In case of doubt, consult a qualied specialist dealer
or your vehicle’s manufacturer.
The roof duct provides a watertight seal through which the three cables (2 x coaxial cables, one power supply cable)
are fed into the interior of the vehicle directly underneath the turntable. If you prefer a different method of laying the
cables, you can run them out from the rear of the turntable via the channel provided in the mounting plate. The cables
must then be run along the roof of the vehicle in a protective cable duct and through a separate roof duct HDZ100
(neither of them are included in the scope of delivery).
The HDZ100 roof duct is available as an accessory under part number 20410032 from specialist dealers.
NOTICE
Risk of malfunction or material damage, in particular due to the absence of a blade fuse in the cable!
Protect the positive wire (red) of the power supply cable by using a 15A blade fuse.
The fuse must be installed by a specialist.
If the fuse is blown, replace it by a fuse of the same rating (15A).
Eliminate the cause of the fault.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein CAP 650 - MobiSet 3 Twin at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein CAP 650 - MobiSet 3 Twin in the language / languages: English as an attachment in your email.

The manual is 7,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein CAP 650 - MobiSet 3 Twin

Kathrein CAP 650 - MobiSet 3 Twin User Manual - German - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info