477906
8
Zoom out
Zoom in
Previous page
1/96
Next page
8 English
You need to use the matching high-pres-
sure nozzles to ensure that your high-pres-
sure cleaner works properly.
Note: Nominal pressure (p): See Operating
Instructions or type plate of your high-pres-
sure cleaner.
e.g.: K 6 – K 7, Kärcher 600 – Kärcher 770
Î Use yellow high-pressure nozzles.
Note:The yellow high-pressure nozzles
have already been installed.
e.g.: K 4 – K 5, Kärcher 201 – Kärcher 560
Î Use grey high-pressure nozzles.
Î Illustration
1 Loosen the safety clamp with a screw-
driver.
2 Remove the protective grid.
3 Change the high pressure nozzles.
4 Mount the protective grid on the pin.
5 Push the safety clamp in until it locks.
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Î Illustration
1 Screw the two extension pipes togeth-
er.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Î Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Caution
Î Illustration
Do not run over free-standing corners!
The T-Racer is not suited for scouring
or scrubbing!
Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
Î Adjust the turning handle "power" as
per the surface to be cleaned
Î Adapt the slide controller Hoovercraft
effect to the ground.
Fasten the T-Racer directly to the high-
pressure gun.
Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
Tighten the safety cover.
Caution
Î Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
Î Adjust the turning handle "power" as
Preparing the Appliance
Selecting the high-pressure nozzles
High-pressure cleaner with nominal
pressure (p) of 13 MPa (130 bar) to 16
MPa (160 bar)
High-pressure cleaner with nominal
voltage (p) lesser than 13 MPa (130 bar)
Changing the high-pressure nozzles
a Remove the clip.
b Pull out the yellow high-pressure noz-
zle.
c Insert the grey high-pressure nozzle.
d Re-insert the clip.
Application
Cleaning floor surfaces
Cleaning wall surfaces
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher T 300 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher T 300 Plus in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 4,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info