804574
11
Zoom out
Zoom in
Previous page
1/164
Next page
English 11
Cleaning of coated or painted surfaces
Wax, furniture polish, plastic coatings or paint can come
off or stains may occur when cleaning painted or plastic-
coated surfaces such as e.g. kitchen and living room
furniture, doors, parquet or linoleum. To clean these sur-
faces, steam a cloth briefly and wipe it over the surfac-
es.
Glass cleaner
Preheat the window pane in seasons with particularly
low temperatures. To do this, lightly steam the entire
glass surface at a distance of approx. 50 cm. This
avoids tension on the surface that can lead to glass
breakage.
Initial startup
Installing accessories
1. Open the cover of the device socket and plug the
steam connector tightly into the device. The lugs of
the plug must latch on the cover of the device sock-
et.
2. Connect the accessory (floor nozzle, manual nozzle
or spotlight nozzle) to the steam gun. Push the parts
together until the locking button on the steam gun
engages.
3. Use extension tubes if necessary. Push the parts to-
gether until the respective locking button engages.
4. Press the locking button to separate the accessories.
Filling water
Note
Distilled water (no limescale formation) can be used but
this leads to faster wear of the boiler and is thus not rec-
ommended.
1. Check that the safety lock is seated tightly.
2. Unscrew the reservoir cap from the fresh water tank.
3. Insert the filler funnel into the fresh water tank and
turn it to latch it in place.
4. Pour approximately 2 litres of tap water into the
fresh water tank.
Do not use detergents!
5. Unlock and remove the filler funnel.
6. Screw the reservoir cap onto the fresh water tank.
Operation
Temperature indicator
The temperature indicator shows if the correct temper-
ature range is being used (working temperature range).
Switching on the device
The heating switches on periodically during use (in-
dicator light lights up yellow) to maintain the pres-
sure in the boiler.
If the device is switched on without water, the "Heat-
ing" indicator light lights up yellow until the water
shortage thermostat switches the heating off. The
"Steam boiler water shortage" indicator light then
lights up red.
1. Plug the mains plug into a mains socket.
2. Switch on the unit with the fresh water tank pump
switch and the heating switch. The indicator lights
light up.
Note
The full heating capacity is only available if the steam
connector is connected to the device when it is heating
up. The system is ready for operation when the "Heat-
ing" indicator light goes out.
Note
Do not stand the device upright when it is switched on.
Otherwise the heating switches off automatically after a
short time and the "Steam boiler water shortage" indica-
tor light lights up red.
3. Switch off the heating at the switch when transport-
ing the device.
4. Press the steam switch, steam comes out. Always
point the steam gun at a cloth first until the steam
flows out evenly.
Steam quantity regulation
Note
If the steam quantity regulation is set to a small quantity,
steam may still escape briefly after releasing the steam
switch until the pressure in the steam hose is released.
This pressure can also be released more quickly by set-
ting the steam quantity regulation to large quantity for a
short time.
1. Adjust the steam quantity using the rotary knob on
the device when working with standard accessories.
VAPOHYDRO regulation with rotary knob
In wet areas, the dirt can also be washed away in-
stead of being picked up with the cloth. For this, ad-
just the moisture content of the steam using the
VAPOHYDRO regulation rotary knob. The higher
the moisture content of the steam, i.e. the steam jet
contains more water, the greater the flushing effect.
The rinsing effect is greatest when the rotary knob is
turned anticlockwise to the largest amount (+) so
that a hot water jet is emitted.
We recommend using the VAPOHYDRO in conjunc-
tion with the spotlight nozzle for e.g. cleaning in the
bathroom.
Turn the rotary knob of the VAPOHYDRO regulation
clockwise to the smallest quantity (-) when working
with cloths (floor nozzle, manual nozzle) to provide
as little moisture as possible in the steam jet. This
improves the dirt-dissolving power of the steam.
Note
The boiler empties more quickly when the rotary knob of
the VAPOHYDRO regulation is turned anticlockwise to
the largest quantity (+).
Refilling water
Note
An acoustic signal sounds and the "fresh water tank wa-
ter shortage" indicator light lights up red when the water
in the fresh water tank is used up.
Note
If the pump does not deliver water despite a full fresh
water tank, the boiler must be descaled.
1. Fill a maximum off 2 litres of tap water into the fresh
water tank using the filler funnel. The "Fresh water
tank water shortage" indicator light goes out. The
system is ready for operation when the "Heating" in-
dicator light goes out.
Disconnecting accessories
DANGER
Danger from hot water
Risk of scalding
Never disconnect accessories while steam is being re-
leased as hot water may drip out. Allow the device to
cool down first.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SG 4-4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SG 4-4 in the language / languages: All languages as an attachment in your email.

The manual is 5.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info