477968
15
Zoom out
Zoom in
Previous page
1/194
Next page
- 4
Health risk, risk of damage!
Check the object to be cleaned prior to using
the appliance in an inconspicuous place for
colour fastness and water resistance.
Do not clean water-sensitive floor coverings
such as wood floors (the moisture could pen-
etrate and damage the floor).
Notes:
Warm water (max. 50°C) will increase the
cleaning effect.
Only use detergent pump while operating.
Avoid dry runs as well as unnecessary pres-
sure buildup (dynamic pressure) as much as
possible.
In case of danger of overheating, the thermal
protection switch shuts off the detergent
pump. After cooling off (approx. 20 min), the
pump will be ready to use again.
Illustration
You can remove the water reservoir to fill it.
Add 100 - 200 ml (volume depends on degree
of contamination) of RM 519 into the fresh wa-
ter reservoir, then add tap water - do not over-
fill (watch MAX marker).
Use the wash floor nozzle.
Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
Do not clean laminate or parquet floors!
Use the wash floor nozzle.
Slide the attachment for hard surfaces
onto the wash floor nozzle from the side.
Use the wash hand nozzle.
Illustration
Insert the mains plug into the socket.
Press the switch for vacuuming, suction
turbine is running.
Illustration
Close fully the surrounding air separator
at the handle.
Illustration
Press the switch for spraying, the deter-
gent pump is ready.
Illustration
Use the lever on the spray handle to spray
on detergent solution.
Illustration
For continuous spray, the spray lever can
be locked; for this, activate the spray lever
and pull the locking key toward the rear.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Once the wastewater container is full, the
appliance switches off automatically.
Note: Once the appliance shuts off,
switch off the appliance, because the suc-
tion turbine will otherwise start running
again once you open the appliance.
Release and remove the appliance head.
Remove the wastewater container and
empty it.
Rinse the spray tubes in the appliance as
follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.
Always work from the light to the shade
(from the window to the door).
Always work from the cleaned to the un-
cleaned surface.
Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care Tex
RM 762 after the wet cleaning prevents a
quick resoiling of the textile surface.
Wet cleaning of carpets/hard sur-
faces/upholstery
Fill the fresh water reservoir
Wet cleaning of carpeted floors
Wet cleaning of hard surfaces
Wet cleaning of upholstery
Start working
Empty the wastewater reservoir during
operation
End wet cleaning process
Cleaning tips/mode of operation
15EN
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SE 6.100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SE 6.100 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 4,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info