478713
16
Zoom out
Zoom in
Previous page
1/198
Next page
– 5
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
Remove the accessories and the fresh
water reservoir and unlatch the motor
casing.
Remove the motor casing and empty
the reservoir.
Always work from the light to the shade
(from the window to the door).
Always work from the cleaned to the un-
cleaned surface.
Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
Turn on suction and spraying
(position I).
Spray and simultaneously suction off
detergent solution in one work cycle.
Switch off the spray switch and suction
off the remaining cleaning solution.
After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
Switch on sprayer (position I).
Apply detergent solution and soak for
10 to 15 minutes (suction is switched
off).
Clean the surface just like you would
with light/normal soiling.
After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
Rinse the spray tubes in the appliance
as follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.
Caution
Always work with the filter bag inserted, ex-
cept when a cartridge filter is used (option).
The reservoir and accessories must be dry
to prevent parts from sticking together.
Illustration
Insert a filter bag.
Illustration
Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn
the locking handle to secure it.
Select the desired accessories and at-
tach to the spray/suction pipes or direct-
ly to the attachment.
Switch on suction (position I).
Illustration
Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Illustration
Work without the hard surface insert.
Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
Cleaning tips/mode of operation
Cleaning methods
Light/normal contamination
Heavy soiling or stains
End wet cleaning process
Dry vacuum cleaning
Vacuuming hard surfaces
Vacuuming carpeted floors
16 EN
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SE 4002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SE 4002 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info