Manual Karcher SE 3-18 Compact (page 13 of 148) (All languages)

803783

Zoom out

Zoom in

1/148

English 13

8. Remove the battery pack, see chapter Removing

the battery pack.

9. Charge the battery pack if necessary.

10. Empty the waste water tank, see chapter Emptying

the waste water tank.

11. Thoroughly rinse the waste water tank with clear

water.

12. If necessary, e.g. if the sieve in the fresh water tank

is contaminated, rinse the fresh water tank with clear

water, see chapter Cleaning the waste water tank

cap and separator.

13. Disconnect the accessories from the device.

14. To remove any remaining liquid in the spray/suction

hose:

a Press the catch and remove the spray/suction

hose from the device.

b Press the lever on the handle and let the liquid

flow out.

Note

To allow the liquid to dry completely, do not wrap the

spray/suction hose around the device to dry.

Note

To avoid puddles in the living area (e.g. on carpet, par-

quet), let the remaining liquid run in a suitable container

(e.g. sink, bucket).

15. Rinse the upholstery nozzle with tap water and let

the device dry with the other accessories.

16. Stow the device in the "drying position" (with the two

tank lids slightly open so that any remaining liquid

can dry without leaving any residue).

Emptying the waste water tank

1. Pull out the dirty water tank vertically upwards by the

recessed grip.

Illustration O

2. Unlock the two side ones tank caps, remove the fill-

er cap and dispose of waste water.

Illustration P

3. When continuing the cleaning work: Replace the fill-

er cap, making sure that it is firmly seated. Insert the

waste water tank down to the bottom of the device.

4. At the end of the cleaning work: Stow the device in

the "drying position" (the filler cap is slightly open

and any remaining liquid can dry without leaving any

residue).

Cleaning the waste water tank cap and

separator

Note

2 grids are fitted to the inside of the waste water tank

cover (on the separator). If the grids are wet or dirty, the

float may not switch correctly or the device may switch

off too early.

Therefore, ensure that the grids are clean and dry dur-

ing operation.

1. Remove the waste water tank from the device, see

chapter Emptying the waste water tank

2. Remove the tank lid from the tank and remove the

separator.

3. Carefully clean the tank lid and separator with a

damp cloth.

4. Carefully remove moisture with a dry cloth.

Illustration Q

5. Fit the tank lid and separator together, fasten on the

tank and fit them back into the device.

Removing the battery pack

Note

During longer work breaks, remove the battery pack

from the device and secure it against unauthorised use.

●Push the battery pack upwards and remove it from

the device.

Illustration R

Storing the device

●Fasten the crevice nozzle to the accessory holder.

●Wrap the suction hose around the device and fasten

it to the other accessory holder with the upholstery

nozzle.

Illustration S

Illustration T

●Store the device in a dry and frost-free room.

Transport

몇CAUTION

Failure to observe the weight

Risk of injury and damage

Be aware of the weight of the device during transporta-

tion.

Manual transport

1. Lift and carry the device by the carrying handle.

Transport in vehicles

1. Secure the device against slipping and tipping over.

Care and service

Device and accessories

1. Clean the device and accessory parts made of plas-

tic with a commonly available plastic cleaner.

2. Rinse the container and accessories with water as

necessary and dry them thoroughly before further

use.

3. Regularly check the battery terminals for soiling and

clean them as necessary.

Cleaning the fresh water filter

Note

On the bottom of the fresh water tank there is a filter on

which dirt particles can settle and thereby obstruct the

water flow.

Therefore, regularly rinse out the fresh water tank.

1. Remove the fresh water tank from the device, see

Chapter Filling the fresh water tankFilling the fresh

water tank.

2. Rinse out the fresh water tank with clean water.

3. Insert the fresh water tank back into the device.

Troubleshooting guide

Device not running

Battery pack not correctly seated in the battery pack

mounting.

1. Push the battery pack into the battery pack mount-

ing until it latches into place.

Note

If necessary, remove the battery pack again and reinsert

it until it latches into place.

Charging state of the battery pack (see display) too low.

1. Charge the battery pack.

Defective battery pack or charger.

1. Replace the battery pack or charger.

Device switches off automatically

Device/battery pack overheated.

Wait until the device/battery pack has cooled down.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SE 3-18 Compact in the language / languages: All languages as an attachment in your email.

The manual is 3.22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher SE 3-18 Compact Manual

Product: