477953
14
Zoom out
Zoom in
Previous page
1/64
Next page
Illustration
Unfold the folding legs if you are work-
ing without pre-filter (only SCP 12000 ).
You can buy the pre-filter as an acces-
sory.
Illustration
In the Automatic mode set the level
switch to the desired switching height.
Illustration
If the switching height is inadequate for
automatic mode press together the
clamps of the level sensor, remove the
level sensor out of the guiding tracks
and position it to the desired switching
height.
Illustration
In manual mode press together the
clamps of the level sensor and remove
it from the guide tracks. Press the level
sensor at the bottom into the guide
tracks and push it upwards till the sen-
sor locks into the contact bracket.
Illustration
Place the pump on a level, stabile sur-
face in the liquid to be transported, en-
sure that it is standing firmly or immerse
it using a rope tied to the handle.
The suction area should not be blocked
fully or partially through the impurities.
The fluid level must be minimum 3 cm (SCP
1200) or 8 cm (SDP 14000) for the pump to
suck in automaticallt.
If the liquid level is less than 4 cm (only
SCP 12000), proceed according to instruc-
tions in the chapter of flat suction.
Plug in the main plug.
In the automatic mode, the level switch
controls the pumping operations. The
pump starts when the fluid level reaches
the level sensor. The pump switches off au-
tomatically after 10 to 60 seconds (depend-
ing on the ambient conditions) when the
fluid level falls below the level sensor. The
pump automatically conducts the adapta-
tion to the necessary trail time. Thi setting
remains saved for a max. of 24 hours or un-
til the mains plug is pulled out. If the mains
plug is pulled prior to the 24 hour time peri-
od, or after the 24 hours have elapsed, the
pump will automatically set the trail time to
the set value of 10 seconds.
The optimising of the trail time prevents fre-
quent switching on and off of the pump dur-
ing rapidly increasing water levels. In this
case, the pump will work even more effec-
tively, the higher the level sensor is in-
stalled.
In manual opertions the pump remains
switched on continuously.
Note:
Dry run leads to increased wear and tear;
do not leave the pump unattended when it
is running. Switch off the pump within 3
minutes of dry running.
Operation
Automatic operation
Manual operation
14 English
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SDP 14000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SDP 14000 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info