724900
13
Zoom out
Zoom in
Previous page
1/198
Next page
English 13
23 Spotlight nozzle
24 Round brush (small)
25 **Power nozzle
26 **Round brush (large)
27 Manual nozzle
28 Manual nozzle microfibre cover
29 Extension tubes (2 x)
30 Unlocking button
31 Floor nozzle
32 Hook and loop fastener
33 Microfibre floor cloth (1 x)
34 **Microfibre floor cloth (2 x)
35 **Carpet glider
36 Descaler
37 Steam pressure iron
38 Indicator light (orange) - heating
39 Steam switch (bottom)
40 Steam connector
** optional
Installation
Installing accessories
1. Insert and engage the steering roller and non-driven
wheels.
Illustration B
2. Open the cover on the device socket.
Illustration E
3. Connect the steam connector to the device socket
so that the steam connector audibly engages.
Illustration E
4. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration J
5. Push the open end of the accessory onto the spot-
light nozzle.
Illustration K
6. Connect the extension tubes with the steam gun.
a Push the first extension tube onto the steam gun
so that the unlocking button on the steam gun en-
gages.
The connection pipe is connected.
b Push the second extension tube onto the
first extension tube.
The connection pipes are connected.
Illustration L
7. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration M
The accessory is connected.
Disconnecting accessories
1. Set the selector switch for the steam volume to the
rear.
The steam lever is locked.
2. Push the cover on the device socket down and discon-
nect the steam connector from the device socket.
3. Push the unlocking button and pull the parts apart.
Illustration R
Operation
Filling water
The water reservoir can be removed at any time for fill-
ing or be filled directly at the device.
ATTENTION
Damage to the device
Unsuitable water can block the nozzles or damage the
water level indicator.
Do not fill in pure distilled water. Use a maximum of 50%
distilled water mixed with tap water.
Do not use condensation from the clothes dryer for filling.
Do not use collected rain water for filling.
Do not use cleaning agents or other additives (e.g.
scents) for filling.
Remove the water reservoir for filling
1. Pull the water reservoir vertically upwards.
Illustration C
2. Fill the water tank vertically with tap water or a mix-
ture of tap water and no more than 50% distilled wa-
ter up to the "MAX" mark.
3. Insert the water reservoir and press downwards until
it locks into place.
Filling the water reservoir directly on the device
1. Fill tap water or a mixture of tap water and no more
than 50% distilled water from a vessel into the filling
hole of the water reservoir up to the "MAX" mark.
Illustration D
Switch on the device
Note
If there is no or too little water in the steam boiler, the
water pump starts to run and pumps water from the wa-
ter reservoir into the steam boiler. The filling process
can take several minutes.
Note
The device briefly closes the valve every 60 seconds
causing an audible soft click. Closing prevents the valve
from clogging. This does not affect the steam output.
1. Place the device on a firm surface.
2. Insert the mains plug into a socket.
Illustration F
3. Press the ON switch.
The green heating indicator light flashes.
Illustration G
4. Wait until the green heating indicator stays on.
Illustration H
5. Press the steam lever.
Illustration I
Steam leaks out.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SC 4 EasyFix Premium Iron at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SC 4 EasyFix Premium Iron in the language / languages: All languages as an attachment in your email.

The manual is 28,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info