803423
13
Zoom out
Zoom in
Previous page
1/188
Next page
English 13
Switching on the device
ATTENTION
Device damage due to incorrectly set water hard-
ness
The decalcification cartridge only works properly if the
device is adjusted to the local water hardness. The de-
vice may calcify if the water hardness is set incorrectly.
Adjust the device to the local water hardness before first
operation, see chapter Setting the water hardness.
Note
When steaming for the first time after removing and re-
inserting the decalcification cartridge, the steam jet may
be weak or irregular, and individual drops of water may
be expelled. The device requires a short running-in pe-
riod in which the decalcification cartridge fills with water.
The steam volume that is expelled increases constantly
until the maximum steam volume has been reached af-
ter approx. 30 seconds.
1. Place the device on a firm surface.
2. Connect the mains plug into a socket.
3. Press the On/Off switch.
Illustration I
4. The LED strip is in fading red.
5. The LED strip lights up in a constant green after ap-
prox.30 seconds.The device is ready for use.
Illustration J
Regulating the steam volume
The expelled steam volume is regulated by pressing the
steam volume button. Two different steam volume but-
tons are available:
Illustration K
Note
The maximum steam volume is always selected when
the device is switched on.
1. Press the steam lever after setting the steam vol-
ume.
2. Before starting cleaning, point the steam gun at a
cloth until steam is expelled evenly.
Topping up the water
If there is a water shortage, the LED strip rapidly flashes
red.
For constant steam output, the water has to be topped
up through the cover of the decalcification cartridge.
When topping up the water, the decalcification cartridge
remains secured in the device.
Note
The device is equipped with dry-run protection for the
pump. If the pump runs dry for a longer period, e.g. be-
cause the decalcification cartridge is not correctly in-
serted, the pump switches off and the red water
shortage indicator light flashes.
To be able to operate the device again, the device has
to be switched off and back on again. In the process,
you must make sure that the cartridge has been insert-
ed correctly and there is enough water in the water res-
ervoir.
1. Fill the water reservoir with a maximum of 1 l of tap
water through the cover of the decalcification car-
tridge.
The LED strip lights up in a constant green.
Interrupting operation
In order to save energy, we recommend that you switch
off the device for breaks in operation of longer than 20
minutes.
1. Press the On/Off switch.
Switching off the device
1. Press the On/Off switch.
Illustration L
The device has been switched off.
2. Press the steam lever until no more steam flows out.
Illustration M
The steam boiler is depressurised.
3. Move the child lock back.
The steam lever is locked.
4. Remove the mains plug from the socket.
ATTENTION
Device damage due to water putrefaction
If the device is not put into operation for more than 2
months, the water in the reservoir may putrefy.
Drain the water reservoir before breaks in operation.
5. Remove the decalcification cartridge from the de-
vice.
Illustration N
Storing the device
1. Hang the floor nozzle in the park bracket.
Illustration O
2. Connect the extension tubes to the large mounts for
accessories.
3. Connect a manual nozzle and spotlight nozzle to
each extension tube.
4. Wrap the cable and place it in the accessory storage
area.
5. Place the small round brush and power nozzle in the
accessory storage area.
6. Put the steam hose in the accessory storage area.
Illustration P
7. Store the device in a dry location that is protected
from frost.
Important application instructions
Cleaning the floor areas
We recommend sweeping the floor or vacuum cleaning
it before using the appliance. In this way the floor will be
cleared of dirt and loose particles before the wet clean-
ing.
Freshening up textiles
Prior to using the appliance, always check the compati-
bility of the textiles at a concealed point: Steam down
the textile, allow it to dry and then check it for any
change in colour or shape.
Cleaning coated or painted surfaces
ATTENTION
Damaged surfaces
Steam can loosen wax, furniture polish, plastic coatings
or paint and edge band from edges.
Maximum steam volume
Reduced steam volume
No steam - child lock
Note
In this position, the steam lever cannot
be operated.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SC 3 Deluxe EasyFix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SC 3 Deluxe EasyFix in the language / languages: All languages as an attachment in your email.

The manual is 18.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info