478136
19
Zoom out
Zoom in
Previous page
1/226
Next page
– 11
You can use the wallpaper remover with
the steam cleaner to remove paper wallpa-
pers.
Place the entire surface of the wallpa-
per remover along the edge of a strip of
wallpaper. Switch on the steam supply
and allow the steam to act on the wall-
paper until it is completely soaked (ap-
proximately 10 seconds).
Move the wallpaper remover to the next
piece of wallpaper you want to remove.
Hold the steam switch pressed while
you move the tool. Lift the soaked piece
of wallpaper using a flat trowel, and pull
it off the wall. Move the wallpaper re-
mover from strip to strip, and pull the
wallpaper off in strips.
In case of woodchip wallpaper that has
been painted several times, the steam
may not be able to soak the wallpaper.
Thus, we recommend to prepare the
wallpaper using a spiked roller before
steam is applied.
ƽ Danger
Always disconnect the mains plug and al-
low the steam cleaner to cool down before
performing any maintenance work.
Rinse the steam cleaner boiler at the latest
after 5 boiler fillings.
Fill the boiler with water and shake it
strongly. This dissolves lime scaling re-
siding on the boiler bottom.
Empty water out.
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
As limescale builds up on the boiler walls,
we recommend to descale the boiler in the
following intervals (RF=reservoir fillings):
Note: Please contact your Conservancy
Board or the local water supply company to
inquire about the hardness of your water.
Disconnect the mains plug from the
socket.
Allow device to cool down.
Remove the safety cap from the device.
Completely empty the steam boiler to
remove existing water (see fig. ).
Warning
Only use products approved by KÄRCHER
to exclude any damages of the appliance.
User the KÄRCHER decalcifier sticks
(order no. 6.295-047) to decalcify the
water. Please follow the dosing instruc-
tions on the packaging while using the
decalcifying solution.
Caution
Use caution when filling and emptying the
steam cleaner. The descaling solution can
have an aggressive effect on delicate sur-
faces.
Pour the descaling solution into the boil-
er and allow it to react for approximately
8 hours.
Warning
Do not screw the safety lock on the appli-
ance during the decalcifying.
Do not use the steam cleaner as long as
there is decalcifying agent in the boiler.
Completely empty the descaling solu-
tion after 8 hours. A small amount of the
solution will remain in the boiler. There-
fore, you should rinse the boiler two to
three times with cold water to remove
any residues of the descaler.
Completely empty the steam boiler to
remove existing water (see fig. ).
Wallpaper remover (optional)
Maintenance and care
Rinsing the boiler
Descaling the boiler
Degree of hardness ° dH mmol/l RF
I soft 0- 7 0-1,3 55
II medium 7-14 1,3-2,5 45
III hard 14-21 2,5-3,8 35
IV very hard >21 >3,8 25
19EN
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SC 1.010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SC 1.010 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info