804554
11
Zoom out
Zoom in
Previous page
1/148
Next page
English 11
33 Wastewater container, removable
34 Wastewater container carrying handle
35 Cover seal
36 Fluff filter
Table of nozzle mouthpieces
Start-up
1. Check the power cord, extension cable and hoses
for damage before each start-up.
Installing accessories
1. Fit the suction pipe onto the floor nozzle and hand-
tighten the union nut on the floor nozzle.
2. If necessary, slide the D-handle onto the suction
pipe and hand-tighten in the desired position. The
D-handle is easier to slide on with the help of dish-
washing detergent or other lubricant.
3. Fit the handle onto the suction pipe and hand-tight-
en the union nut on the handle.
4. Connect the suction hose to the suction hose con-
nection on the device. Insert the spray hose cou-
pling into the spray hose connection on the device
and latch into place.
5. Connect the suction hose to the handle. Connect
the spray hose coupling to the handle and latch into
place.
Mixing the cleaning solution
DANGER
Danger from detergents
Risk of injury and damage
Observe all instructions that are included with the deter-
gents used.
Note
Warm water (maximum 50 °C) increases the cleaning
effect. Check the temperature resistance of the surface
to be cleaned.
Note
Use detergents sparingly to conserve the environment.
1. Mix fresh water and detergent in a clean container
(concentration as specified for the detergent). Dis-
solve the detergent in the water.
Filling the fresh water tank
1. Pour the cleaning solution into the fresh water tank.
The filling level must not exceed the "MAX" mark.
Defoaming agent
Note
Foam is generated in the wastewater container when
cleaning previously shampooed carpets. Foaming can
be prevented by adding defoaming agents.
1. Puzzi 10/1 only: Add defoaming agent (special ac-
cessory) to the wastewater container.
2. Puzzi 10/2 Adv only: Open the defoaming agent
container. Fill with defoaming agent (special acces-
sories).
Replacing the carpet adapter
1. Press the floor nozzle latch on one side.
2. Swing out and remove the carpet adapter.
3. Insert a new carpet adapter and engage the latch.
Operation
Working with accessories
Puzzi 10/2 Adv only:
Note
An additional power socket is provided for connecting
additional electrical devices.
DANGER
Danger of electric shock
Risk of injury and damage.
The socket is only intended for the direct connection of
the PW 30/1 additional brush washer head to the Puzzi
10/2 Adv. Any other use of the socket is prohibited.
Switching on the device
1. Connect the mains plug.
2. Press the suction switch to switch on the suction tur-
bine.
3. Press the spray switch to switch on the spray pump.
Cleaning mode
ATTENTION
Danger from cleaning solution
Risk of damage
Before using the device, check the object to be cleaned
for colour fastness and water resistance in an inconspic-
uous place.
1. Press the lever on the handle to spray the cleaning
solution.
2. Run over the surface to be cleaned in overlapping
paths. Pull the nozzle backwards (do not push).
3. When interrupting work, the suction pipe (with floor
nozzle) can be placed in the carrying handle of the
device.
Switching off the device
1. Switch off the spray switch and the suction switch.
2. Pull out the mains plug.
Empty the wastewater container
1. Switch off the suction switch and the spray switch
when the wastewater container is full.
2. Remove the cover.
3. Remove the wastewater container from the device
and empty it.
Emptying the fresh water tank
1. Switch off the device.
2. Briefly operate the lever on the handle to relieve
pressure.
3. Disconnect the handle from the spray/suction hose.
4. Hang the suction hose in the fresh water tank.
Colour Part
number
Flow vol-
ume
Applica-
tion
Approved
for device
Yellow 6.415-
165.0
2.0 l/min Floor noz-
zle
Puzzi 10/2
Green 6.415-
105.0
0.7 l/min Floor noz-
zle
Puzzi 9/1 Bp
Brown 6.415-
166.0
1.0 l/min Floor noz-
zle
Puzzi 8/1,
Puzzi 10/1
Blue 6.415-
928.0
1.0 l/min Uphol-
stery noz-
zle
Puzzi 8/1,
Puzzi 10/1,
Puzzi 10/2,
Puzzi 30/4
Red 6.415-
097.0
0.55 l/min Uphol-
stery noz-
zle, short
Puzzi 8/1,
Puzzi 9/1 Bp
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher Puzzi 10-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher Puzzi 10-1 in the language / languages: All languages as an attachment in your email.

The manual is 5.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info