Manual Karcher KWD 3 P S (page 9 of 84) (All languages)

803413

Zoom out

Zoom in

1/84

English 9

Position : When the power tool is connected,

the suction is activated automatically.

Position "0 OFF": The device is switched off.

Note

As long as the device is supplied with power, the device

socket can be used as a power source.

Note

Limited for Switzerland only: The socket outlet shall on-

ly be used during operation in dry condition.

Operation

Note

Pay attention to the latest part numbers when purchas-

ing and installing filter bags and cartridge filters.

Information on accessories and spare parts can be

found at www.kaercher.com.

Dry vacuuming

ATTENTION

Vacuuming cold ashes

Device damage

Only vacuum cold ash with an ash pre-separator.

ATTENTION

Defective or wet foam filter / cartridge filter

Device damage

Before starting up, check the foam filter / cartridge filter

for damage, and replace it if necessary. Only vacuum

with a dry foam filter / cartridge filter.

Depending on the equipment variant, a foam filter or a

cartridge filter is included.

For devices with a foam filter: Always use the filter

bag in addition to the foam filter when dry vacuum-

ing.

For devices with a cartridge filter: Always use the fil-

ter bag in addition to the cartridge filter when vacu-

uming fine dust.

Note

Replace the filter bag in good time, as a filter bag that is

too full could be damaged. The fill degree of the filter

bag depends on the amount of dirt vacuumed. The filter

bag should be replaced more frequently when vacuum-

ing fine dust, sand, etc.

Wet vacuuming

ATTENTION

Wet vacuuming with a filter bag

Device damage

Do not use a filter bag when vacuuming wet.

ATTENTION

Operation with full container

When the container is full, a float switch closes the suc-

tion opening and the device runs at a higher speed.

Switch off the device immediately and empty the con-

tainer.

Note

If the device falls over, the float can also close. To make

the device capable of vacuuming again, set up the de-

vice, switch it off, wait 5 seconds and then switch it on

again.

Working with power tools (only for devices

with a built-in socket)

몇CAUTION

Unintentional starting of the power tool

Injury or property damage

Make sure that the power tool is ready for operation as

soon as it is connected to the device socket.

1. Connect the suction hose.

Illustration F

2. If necessary, adjust the adapter to the connection di-

ameter of the power tool using a suitable tool.

3. Put the adapter on the handle of the suction hose.

4. Mount the suction hose with the adapter on the pow-

er tool.

Illustration L

5. Plug the mains plug of the power tool into the device

socket.

Illustration M

6. Set the trigger to .

Illustration K

The suction is activated automatically.

Note

Note the maximum connected load (see information on

the device socket).

Note

As soon as the power tool is switched on, the suction

turbine starts up with a 0.5 second delay. If the power

tool is switched off, the suction turbine continues to run

for approx. 5 seconds in order to suck in the residual dirt

in the suction hose.

Blower function

The blower function can be used to clean areas that are

difficult to reach or where vacuuming is not possible,

e.g. leaves in a gravel bed.

Insert the suction hose into the blower connection.

The blower function is now activated.

Illustration N

Interrupting operation

1. Set the trigger to "0 OFF".

The device is switched off.

2. Variant 1: Place the handle of the suction hose in the

intermediate parking position.

Illustration O

Variant 2: Attach the floor nozzle in the parking po-

sition.

Illustration P

Ending operation

1. Set the trigger to "0 OFF".

The device is switched off.

2. Pull out the mains plug.

3. Remove the device head.

Illustration B

4. Empty the container.

Illustration Q

5. Storage possibility:

Illustration T

Note

The suction hose can be wrapped around the device

head and attached to the device head with the help of

the hose collar.

6. Store the device in a dry and frost-proof room.

Care and service

General care instructions

Clean the device and plastic accessory parts with a

commonly available plastic cleaner.

Rinse the container and accessories with water, as

necessary, and dry them before further use.

Clean the foam filter / cartridge filter

1. If necessary, the foam filter / cartridge filter can be

cleaned under running water. To do this, remove the

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher KWD 3 P S in the language / languages: All languages as an attachment in your email.

The manual is 16.43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher KWD 3 P S Manual

Product: