Manual Karcher K 5.60 M (page 11 of 160) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

478514

Zoom out

Zoom in

1/160

English 11

When the appliance is delivered, the HP hose

and trigger gun are not attached, this prevents

buckling. Please mount these before using the

appliance for the first time.

Î Push out the safety clip in the trigger gun us-

ing e.g. a small screwdriver.

Î Join HP hose and trigger gun together.

Î Push clip in until it engages and check that it

is securely fastened by pulling on the HP

hose.

Î Remove cable tie and unroll HP hose

For connection values, see type plate/technical

data.

Observe regulations of water supplier.

Î Use a fibre-reinforced hose (not included)

with a standard coupling: - Minimum diame-

ter, 1/2 inches (13 mm). - Minimum length,

7.5 m.

Î Screw the coupling unit (supplied) to the wa-

ter connection on the appliance.

Î Push the water supply hose onto the cou-

pling unit, then connect it to the tap.

ṇ Caution

Never operate the high-pressure cleaner when

the tap is turned off as dry running will damage

the HP pump.

If the water supply is not clean, the Kärcher water

filter must be used (special accessory - order No.

4.730-059).

The appliance is not suited for use in

the drinking water supply network. It is

necessary to install a suitable system

separator from Kärcher, if the device is

to be used in the drinking water supply network.

When fitted with the appropriate accessories,

this high-pressure cleaner can draw in surface

water, e.g. from water butts or ponds (max. suc-

tion height 0.5 m).

Î Use the Kärcher water filter to protect the HP

pump and accessories (special accessories,

order no. 4.730-059). This filter removes dirt

from incoming water.

Î As the standard coupling system is not suita-

ble for use in suction mode, the Kärcher suc-

tion hose with integrated filter should be used

instead (special accessory, order no. 4.440-

238) and suspended inside the water butt.

Î Remove air from appliance before operation:

Switch on the appliance when the HP hose is

not connected and run it until the water which

discharges from the HP outlet is free of bub-

bles. Switch off appliance and connect HP

hose.

Note: Fill suction hose with water before use,

this will help ventilate the pump of air.

Î Screw HP hose on to HP outlet on appliance.

Î Push the appropriate spray lance on to the

trigger gun and fasten it by turning it to the

right through 90°.

Î Open tap.

Î Plug in mains plug.

Î Set main switch to “I/ON”.

Î Press safety catch on the trigger gun to re-

lease it and pull lever.

ṇ Risk of injury

The trigger gun is subjected to a recoil force

when the water jet is discharged. Make sure that

you have a firm footing and are also holding the

trigger gun and spray lance firmly.

Carrying out the most common cleaning tasks.

The work pressure can be stagelessly regulated

between "Min" and "Max".

Î Release the lever on the trigger gun.

Î Turn the spray lance to the desired position.

For strong contaminations.

Note:

Detergent can only be added when the appliance

is being operated in low pressure mode.

All washing brushes supplied by Kärcher are de-

signed for use with detergents.

Î Use spray lance with pressure regulation

(Vario Power).

Î Turn the spray lance to "Mix" position - low

pressure.

Î During low pressure operation, detergent is

automatically drawn in from the filled deter-

gent tank.

Initial start-up

Water supply

Water supply from mains

Drawing in water from open reservoirs

Start up

High pressure operation

Spray lance with pressure regulation

Spray lance with dirt blaster

Operation with detergent

DT suction infeed from DT tank

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher K 5.60 M in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher K 5.60 M Manual

Product: