Manual Karcher K 4 Full Control (page 15 of 166) (All languages)

657287

Zoom out

Zoom in

1/166

– 9

 DANGER

Risk of electric shock.

 Prior to all work on the appliance, switch off the ap-

pliance and pull the power plug.

Clean the sieve in the water connection regularly.

 Remove coupling from the water connection.

ATTENTION

The sieve must not be damaged.

Illustration

 Pull the sieve out using flat pliers.

 Clean the sieve under running water.

 Reinsert the sieve into the water connection.

The batteries are depleted if nothing is shown on the

display of the trigger gun anymore.

Two batteries or accumulators of the size AAA are re-

quired.

Illustration

 Push the locking slide.

 Open battery compartment.

 Remove the batteries.

 Insert new batteries and observe the correct orien-

tation of the terminals.

 Close battery compartment.

 Dispose of the used batteries according to the local

provisions.

 DANGER

Risk of electric shock. Turn off the appliance and remo-

ve the mains plug prior to performing any care and

maintenance work.

Repair work and work on the electrical components may

only be performed by an authorised customer service.

You can rectify minor faults yourself with the help of the

following overview.

If in doubt, please consult the authorized customer ser-

vice.

 Push the lever of the trigger gun, the device will

switch on.

 Check whether the voltage indicated on the type

plate corresponds to the voltage of the mains sup-

ply.

 Check the mains connection cable for damages.

 Motor overloaded, the motor circuit breaker has

tripped.

– Turn off the appliance "0/OFF".

– Allow the device to cool down for one hour.

– Switch on the device and put it into operation again.

If the malfunction occurs repeatedly, have the de-

vice checked by the customer service.

Voltage reduction due to weak mains supply or when

using an extension cable.

 Upon switch-on, push the lever of the trigger gun

first and then switch the power switch to "I/ON".

 Check setting at the spray lance.

 Check water supply for adequate delivery rate.

 Pull out the sieve in the water connection using flat-

nose pliers and clean under running water.

 Remove air from appliance before operation.

Switch on the appliance without connection the HP

hose (max. 2 minutes) and run it until the water di-

scharging from the HP outlet is free of bubbles.

Switch off appliance and reconnect HP hose.

 Clean high-pressure nozzle: Remove dirt and deb-

ris from the nozzle bore, using a needle and rinse

through with water from the front.

 Check water flow quantity.

 Dropwise leakage of the device is normal for tech-

nical reasons. If the leakage increases contact the

authorized customer service.

 Use Vario Power spray lance.

Turn the spray lance to "Mix" position.

 Check whether the Plug 'n' Clean detergent bottle

is placed into the detergent connection facing

down.

 Check / replace the batteries

Care and maintenance

Clean the sieve in the water connection

Changing the batteries of the trigger gun

Troubleshooting

Appliance is not running

Appliance does not start, motor hums

Pressure does not build up in the appliance

Strong pressure fluctuations

Appliance is leaking

No detergent infeed

No pressure indicator on the trigger gun

15EN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher K 4 Full Control in the language / languages: All languages as an attachment in your email.

The manual is 5,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher K 4 Full Control Manual

Product: