478377
11
Zoom out
Zoom in
Previous page
1/172
Next page
Deutsch 5
The scope of delivery of your appliance is illus-
trated on the packaging. Check the contents of
the appliance for completeness when unpack-
ing.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
These operating instructions describe the maxi-
mum equipment. Depending on the model, there
are differences in the scopes of delivery (see
packaging).
Illustrations on Page 2
1 Coupling element for water connection
2 High pressure connection
3 Appliance switch "0/OFF“/ „I/ON“
4 Detergent Tank
5 Suction hose for detergent
6 Storage for trigger gun
7 Transport handle
8 Storage for high-pressure hose
9 Storage for accessories
10 Mains cable with mains plug
11 Water connection
12 Trigger gun
13 Lock trigger gun
14 High pressure hose
15 Spray lance with Dirtblaster
16 Spray lance with pressure regulation (Vario
Power)
17 Washing brush
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Illustration
Mount loose parts delivered with appliance prior
to start-up.
Illustration
Î Push the high pressure hose into the trigger
gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Î Check the secure connection by pulling on
the high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Î Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Î Screw the coupling element (supplied) to the
water connection on the appliance.
Î Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
This high-pressure cleaner is suited to work with
the KÄRCHER suction hose with backflow valve
(Optional accessory, order no. 4.440-238) to
draw in surface water, e.g. from water butts or
ponds (see specifications for max. suction
height).
Î Fill the KÄRCHER suction hose with back-
flow valve with water, screw to water supply
and hang into the water butt.
Î Separate the high pressure hose from the
high pressure connection of the appliance.
Î Switch the appliance on (I/ON) for a max. of
2 minutes and wait until the water exits the
high-pressure connection without bubbles.
Î Turn off the appliance "0/OFF".
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Troubleshooting".
Operation
Scope of delivery
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up
English 11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher K 3.91 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher K 3.91 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info