Manual Karcher k 2 980 m (page 13 of 196) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

382259

Zoom out

Zoom in

1/196

– 6

Mount loose parts delivered with appliance prior

to start-up.

Illustrations on Page 2

 Illustration

Insert the transport wheels and lock them.

 Illustration

Pull out the clamp for the high-pressure hose

from the trigger gun (e.g. with a small screw-

driver).

 Illustration

Connect high pressure hose to trigger gun.

Push the clamp in until it locks. Check the se-

cure connection by pulling on the high-pres-

sure hose.

According to the applicable regula-

tions, the appliance must never be

used on the drinking water supply with-

out a system separator. Use a suitable

system separator manufactured by KÄRCHER;

or, as an alternative, a system separator as per

EN 12729 Type BA. Water flowing through a sys-

tem separator is considered non-drinkable.

Caution

Always connect the system separator to the wa-

ter supply, never directly to the appliance!

Note: Impurities in the water can damage the

high-pressure pump and accessories. For pro-

tection, the use of the KÄRCHER water filter (op-

tional accessory, order no. 4.730-059) is

recommended.

Observe regulations of water supplier.

For connection values, see type plate/technical

data.

 Use a fibre-reinforced water hose (not in-

cluded) with a standard coupling. (Minimum

diameter 1/2 inch (13 mm), minimum length

7.5 m).

 Screw the coupling element to the water

connection on the appliance.

 Push the water supply hose onto the cou-

pling unit, then connect it to the water supply.

Caution

Dry runs lasting longer than two minutes lead to

damages to the high pressure pump. If the appli-

ance does not build up pressure within two min-

utes, switch it off and proceed as instructed in

the Chapter "Troubleshooting".

 Connect the high pressure hose to the high

pressure connection of the appliance.

 Push the spray lance into the trigger gun and

fasten it by turning it through 90°.

 Completely open the water tap.

 Insert the mains plug into the socket.

 Turn on the appliance “I/ON”.

ṇ Danger

The trigger gun is subjected to a recoil force

when the water jet is discharged. Make sure that

you have a firm footing and are also holding the

trigger gun and spray lance firmly.

 Unlock the lever on the trigger gun.

 Pull on the lever of the trigger gun; the device

will switch on.

Note: Release the lever of the trigger gun; the

device will switch off again. High pressure re-

mains in the system.

Carrying out the most common cleaning tasks.

The work pressure can be stagelessly regulated

between "Min" and "Max".

 Release the lever on the trigger gun.

 Turn the spray lance to the desired position.

For particularly dirty items or areas.

Not suitable for use with detergents.

Suitable for use with detergents.

Please use exclusively KÄRCHER detergents

and care products to carry out the respective

cleaning task, as these were specifically devel-

oped for your appliance. The use of other deter-

gents and care products may lead to premature

wear and can invalidate your warranty claims.

Please obtain information at your local dealer or

request information directly from KÄRCHER.

 Pull detergent suction hose as far as is re-

quired out of the housing.

 Suspend end of detergent suction hose in a

container filled with detergent.

Before Startup

Water supply

Water supply from mains

Start up

Operation

Spray lance with pressure regulation

Spray lance with Dirtblaster

Washing brush

Working with detergent

13EN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher k 2 980 m in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher k 2 980 m Manual

Product: